Abstract:The gas-solid vertical single helical ribbon agitated reactor is widely used in the polypropylene industry. The gas flow and mass transfer determine the heat transfer capacity and product quality. In this work, the pressure drop was measured below and above minimum fluidization velocity (umf). Then, the axial and radial dispersion coefficients (DL and DR) were estimated below umf by measuring the step residence time distribution and the stationary radial tracer profiles, respectively. Pressure analysis show the agitation significantly reduces the bed pressure drop, changing the fixed bed below umf and bubbling bed above umf to an agitated bed with a periodic voidage. The DL was proportional to the gas velocity, with little influences of the stirring speed. The radial tracer profiles show the bed is divided by the inner diameter of the helical ribbon into the peripheral ascending region and the central descending region, without gas exchange between them. Furthermore. the tracer profiles in the descending region are classified into two types. For type I, the DR, calculated by the plug flow model with radial dispersion, is proportional to the gas velocity, with little effects of stirring speed. Type II shows uniform profiles due to the deflection of the gas flow toward the low pressure area at the inner diameter of helical ribbon. The causes of the two types are explained by the relative size of particle circulation and gas flux. These two flow regimes are quantitatively clarified with an empirical correlation of Re and Fr as flow regime transition boundary, namely dispersed plug flow and perfect mixing flow. With lower Re and higher Fr, it changes from dispersed plug flow to perfect mixing flow.

Minimum fluidization velocity of bimodal polyethylene particles

Study on the Viscosity of Polymer Polyol

Fluidization Characteristics of Polyester Pellets

Wavelets Analysis of Pressure Fluctuation in Agitated Fluidized Bed

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

Thermal stability analysis of ethylene polymerization fluidized bed reactors under condensed mode operation through a TPM-PBM integrated model

Mixing Effects on the Gas Flow and Mass Transfer in a Vertical Single Helical Ribbon Agitated Reactor for Propylene Polymerization

Effect of Temperature Switching and Dynamic Phase Equilibrium on Polymer Microstructure in Condensed-Mode Operation

Heat Transfer of Batch Simulating Continuous Fluidized Bed with Wet Particles

Measurement of the Fluidized Velocity in Gas-Solid Fluidized Beds Based on AE Signal Analysis by Wavelet Packet Transform

Effects of Temperature on Nucleation and Collapse of Volatile Bubbles in the High Density Polyethylene Melt

Investigation of a Dynamic Operation Mode of Ethylene Polymerization Process with a Liquid-Containing Fluidized Bed

Collision Characterization of Mixed Hydrocarbon Liquid Droplets with Polyethylene Particles

Particle Agglomeration and Control of Gas-Solid Fluidized Bed Reactor with Liquid Bridge and Solid Bridge Coupling Actions

Evolution and Fluidization Behaviors of Wet Agglomerates Based on Formation-Fragmentation Competition Mechanism

Characterization of Flow Pattern of Cohesive Particles in Gas-Solid Fluidized Bed Via Axial Distribution of Particle Motions

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Effect of Cohesive Particle Addition on Bubbling Characteristics of Gas-Solid Fluidized Bed: Meso-scale Mechanism

Experimental Study of the Effect of Fluidization Velocity on the Segregation of Two Size Particles System

Modeling of the Minimum Fluidization Velocity and the Incipient Fluidization Pressure Drop in a Conical Fluidized Bed with Negative Pressure

CFD-DEM Investigation of the Fluidization of Binary Mixtures Containing Rod-Like Particles and Spherical Particles in a Fluidized Bed