Abstract:Time-to-digital converters (TDCs) act as a core component in many timing-critical systems. Tapped delay line is the most widely used style for the field-programmable gate-array (FPGA)-based TDCs, but it suffers from several intractable problems such as poor nonlinearity and long delay-line occupation. Recently, a new ring-oscillator-based Vernier TDC circuit using carry chains was demonstrated to have much smaller nonlinearity with a much shorter delay line. Since the used delay line is not compensated, the timing jitter increases (or the precision degrades) remarkably when the oscillation number is large. This would incur undesirable lower resolution selection to maintain acceptable precision. In this article, a novel bidirectional-operating Vernier delay line structure is proposed to reduce the required oscillation number during the fine time measurement. Traditionally, for the Vernier delay line, the fast signal propagates along the slow delay line, while the slow signal propagates along the fast delay line, to which we call the normal Vernier delay line. The new structure proposes two parallelized Vernier delay line, consisting of one normal Vernier delay line and another abnormal Vernier delay line. The term "abnormal" refers to that the fast and slow signals are unusually fed to the fast and slow delay lines, respectively. A prototype TDC circuit based on this new method was implemented on a Stratix III FPGA. Test results demonstrate that by adopting the proposed novel circuit architecture, both the resolution and the root-mean-square error can be improved from the 30–40-ps level to the 20–30-ps level.

Picosecond programmable delay line using commercial components for precision timing signal alignment

Lossless Microwave Photonic Delay Line Using a Ring Resonator with an Integrated Semiconductor Optical Amplifier

Picosecond Optical Pulse Processing Using a Terahertz-Bandwidth Reconfigurable Photonic Integrated Circuit

On-chip delay line based on selection network

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

Large dynamic range digital delay with sub-picosecond precision

Silicon-Based Integrated True-Time Delay Line with Adjustable Large Delays

An Asynchronous Delay Line TDC for ADPLL in 0.13um CMOS.

Photonic-Assisted Time-Interleaved Adc Based on Optical Delay Line

A Multi-Channel Digital Programable Delay Trigger System with High Accuracy and Wide Range

Prototype development of a three-stage, high-precision, low-jitter, wide-range digital delay generator fully utilizing on-chip resources

A Programmable High-Resolution Ultra Fast Delay Generator

A Compact 1–11-GHz 106.7-ps CMOS Passive True Time Delay Chain Implemented by Spiral Transmission Lines

An Active Circulator-Based Delay Line

A High-Linearity Vernier Time-to-Digital Converter on FPGAs With Improved Resolution Using Bidirectional-Operating Vernier Delay Lines

Kintex ultrascale’s multi-segment digital tapped delay lines with controlled characteristics for precise time-to-digital conversion

On-chip Picosecond Resolution Timing Measurement Using Time Amplifier

A High-Resolution TDC Design Based on Multistep Fine Time Measurement by Utilizing Delay-Adjustable Looped Carry Chains on FPGAs

A Picosecond Delay Generator Optimized by Layout and Routing Based on FPGA

An 8-Bit 4Fs-Step Digitally Controlled Delay Element with Two Cascaded Delay Units

Design of a high-precision time-to-digital converter in an Elitestek Ti60 field-programmable-gate-array