Abstract:Owing to the properties of high-transmittance, wear-resisting and lightweight brittle, glass plays an important role in various electronic equipment screens. The laser induced thermal-crack propagation (LITP) can separate the glass with the advantage of the high-quality, high-efficiency and high-strength. However, the deviation of the separation path (which means the material do not separate in the path of laser scanning) is one of the serious problems in asymmetric linear cutting glass with LITP. In this study, a dual laser beam revision the separation path technology (DLBRP) has been developed for the first time by skillfully arranging two defocused diode pump solid state laser (1064nm). The principle of DLBRP is expounded. This paper studied several factors's effects on the cutting quality such as Master laser power (PM), scanning speed (VM) and laser spot diameter (DM).The smaller the Master laser spot diameter, the smaller deviation of the separation path. The effects of revision factors including Accompanying laser power (PA), Accompanying laser spot diameter on the material surface (DA) and the horizontal relative distance between the Master laser and Accompanying laser (∆X) were investigated. The optimum processing parameters were presented in this paper. The cambered separation path (which means the material gets separated in the arc way) in asymmetry linear cutting glass (which means the cutting path deviating from the symmetry axis of the material in a large scale, and the area of two separated parts is varied widely) could be revised into the straight one. A numerical simulation on the thermal stress and the dynamic propagation of crack in the DLBRP for asymmetric linear cutting glass with LITP was developed to analyze the revision mechanism, which is corresponding to the theoretical analysis and experimental results. The analysis of experimental results and numerical simulation results shows that the DLBRP technology can effectively revise the deviation of the separation path in asymmetry linear cutting glass with LITP. Besides, the clean surface without any pollution and surface damage can be achieved.

Dimethicone-aided laser cutting of solar rolled glass

Traceless Mitigation of Laser Damage Precursors on a Fused Silica Surface by Combining Reactive Ion Beam Etching with Dynamic Chemical Etching

Investigation of solar float glass hole cutting using 532 nm nanosecond pulsed laser

Influence of helix geometric parameters on surface quality during laser cutting of photovoltaic float glass

Analysis and comparison of laser cutting performance of solar float glass with different scanning modes

Super stealth dicing of transparent solids with nanometric precision

Thick Glass High-Quality Cutting by Ultrafast Laser Bessel Beam Perforation-Assisted Separation

532 nm Nanosecond laser cutting solar float glass: Surface quality evaluation with different laser spot positions in field lens

Laser cutting sandwich structure glass–silicon–glass wafer with laser induced thermal–crack propagation

Dimethicone-assisted interlaced scanning compound cutting for regulating thermal damage in CFRP laser cutting by synergistic suppression of coupled heat effect

Dual Laser Beam Revising the Separation Path Technology of Laser Induced Thermal-Crack Propagation for Asymmetric Linear Cutting Glass

High quality full ablation cutting and stealth dicing of silica glass using picosecond laser Bessel beam with burst mode

Research on Laser-Assisted Micro-Milling of Fused Silica

Transparent superhydrophobic glass prepared by laser-induced plasma-assisted ablation on the surface

Precision cutting of PDMS film with UV-nanosecond laser based on heat generation-diffusion regulation

Investigation on the crack fracture mode and edge quality in laser dicing of glass-anisotropic silicon double-layer wafer

Centimeter-scale low-damage micromachining on single-crystal 4H–SiC substrates using a femtosecond laser with square-shaped Flat-Top focus spots

Study on 532nm and CO2 laser processing of fused silica glass

Study on the Absorption Characteristics and Laser Damage Properties of Fused Silica Optics under Flexible Polishing and Shallow DCE Process

Dynamic multi-focus laser sculpting of freeform 3D glass microstructures

Study of surface wettability on fused silica by ultrafast laser-induced micro/nano-surface structures