Abstract:The three-dimensional (3D) sculpturing of glass remains a significant challenge owing to its inherent hard and brittle nature. We develop a novel dynamic multi-focus laser sculpting (DMLS) method tailored for 3D glass fabrication. This method employs two-dimensional (2D) spatial multi-focus beams to form sectional profiles of 3D structures, which are modulated by superimposing the phase of Fresnel lenses and blazed gratings. With dynamic switching of phase diagrams on a spatial light modulator, the multi-focus beam rotates and creates a customized 3D laser-modified region inside the bulk glass. Following chemical etching helps remove the modified zones, forming ultimate 3D morphology on glass surface. The feasibility of this method hinges upon achieving uniform foci energy and narrow spatial foci intervals, essential for the precise removal of modified regions through connected crack channels during etching. We propose an extracting strategy to separate foci with random sequences into several groups to disrupt the periodicity of foci, thereby effectively weakening the unexpected Moiré fringes on the phase diagrams. This strategy enables the forming of dense foci by a single diagram with high uniformity, shortening the interval between foci. Further, for the lower surface roughness and higher precision of 3D structures, optimization of fabrication parameters is applied by experimental and numerical analysis. With the above optimization, the DMLS method is capable of carving diversified 3D glass structures, including hemispheres, cones, pyramids, semi-ellipsoids, and petal-like structures. Our method exhibits considerable versatility in processible structures with shape deviation lower than 1.9 μm, showing substantial potential in glass processing.

High quality full ablation cutting and stealth dicing of silica glass using picosecond laser Bessel beam with burst mode

Thick Glass High-Quality Cutting by Ultrafast Laser Bessel Beam Perforation-Assisted Separation

A Machining Science Approach to Dental Cutting of Glass Ceramics Using an Electric Handpiece and Diamond Burs

Good-Quality and High-Efficiency Dicing for Thick LiNbO3 Wafers Using Picosecond Laser Pulses

Study on the Cutting of Medical Glass Tubes Using Picosecond Bessel Beam

Super stealth dicing of transparent solids with nanometric precision

Glass cutting optimization with pump-probe microscopy and Bessel beam profiles

High quality stealth dicing of sapphire with a picosecond Bessel beam by controlling the polarization direction

Glass tube cutting with aberration-corrected non-diffracting ultrashort laser pulses

Laser-Induced-Plasma-Assisted Ablation for Glass Microfabrication

Combined laser cutting process for interior holes in thick glasses

Axial multi-focus stealth cutting method based on the fractional Fourier transform for quartz glass

Dynamic multi-focus laser sculpting of freeform 3D glass microstructures

Study on 532nm and CO2 laser processing of fused silica glass

Glass tube cutting for medical applications using ultrashort-pulsed lasers

Damage morphology and mechanism in ablation cutting of thin glass sheets with picosecond pulsed lasers

High-quality Rapid Laser Drilling of Transparent Hard Materials

An Investigation into Laser-Assisted Electrochemical Discharge Machining of Transparent Insulating Hard-Brittle Material

Analysis and comparison of laser cutting performance of solar float glass with different scanning modes

Water-assisted Drilling of Microfluidic Chambers Inside Silica Glass with Femtosecond Laser Pulses

Liquid-Assisted Femtosecond Laser Precision-Machining of Silica.