Abstract:Sapphire is extensively utilized in the optical, aerospace, and civil electronic industries due to its favorable optical, physical, and chemical characteristics. To enhance the efficiency and quality of sapphire lapping, an orthogonal experiment was conducted on a single-side sapphire substrate using a ceramic lapping plate. The study examined the impact of lapping plate material, lapping pressure, lapping speed, and abrasive particle size on the surface roughness, profile, and removal rate. By analyzing the signal-to-noise ratio and variance of machining parameters, the influence rule and influence of the weight of machining parameters on machining results were obtained. The results of the experiment demonstrate that the material removal rate of sapphire was positively affected by an increase in lapping pressure, speed, and abrasive particle size. Moreover, the removal rate of the SiC lapping plate was the highest among the experimental materials. The roughness of the sapphire surface decreased with increasing lapping pressure, speed, and abrasive particle size, while the SiC plate had the lowest surface roughness. The profile tolerance of sapphire diminished as the lapping pressure, lapping speed, and the abrasive particle size increased. Additionally, the ZrO2 lapping plate exhibited the most minor profile tolerance. The size of the abrasive particle significantly impacted the material removal rate, with a specific gravity exceeding 70%. Similarly, the lapping pressure had a significant effect on both the surface roughness and the profile tolerance. The ideal machining parameter combination comprised an abrasive particle size of 10 μm, a lapping pressure of 22 785.0 Pa, a lapping speed of 60 rpm, and a lapping plate of SiC. Under optimal machining conditions, sapphire exhibited a material removal rate of 0.65 μm/h, a surface roughness of 0.0920 μm, and a profile tolerance of 2.0915 μm after 20 min of lapping. This demonstrated that the lapping process enables highly efficient and high-quality machining of sapphire substrates.

High quality stealth dicing of sapphire with a picosecond Bessel beam by controlling the polarization direction

High quality full ablation cutting and stealth dicing of silica glass using picosecond laser Bessel beam with burst mode

Effect of different grinding strategies on subsequent polishing processes of sapphire

Good-Quality and High-Efficiency Dicing for Thick LiNbO3 Wafers Using Picosecond Laser Pulses

Sub-diffraction-limit fabrication of sapphire by femtosecond laser direct writing

FEMTOSECOND LASER SCRIBING OF SAPPHIRE AT WAVELENGTH 1040 AND 520 NM

Ultrafast pulsed laser stealth dicing of 4H-SiC wafer: Structure evolution and defect generation

Investigation on sapphire ablation by femtosecond-nanosecond dual beam laser

A Method for Preparing Surface Sub-Microstructures on Sapphire Surfaces Using Femtosecond Laser Processing Technology

Material removal and surface formation mechanism of C-plane sapphire in multipass ablation by a nanosecond UV laser

Anisotropic cutting mechanisms on the surface quality in ultra-precision machining of R-plane sapphire

Surface micro-texture on sapphire fabricated by laser ablation trajectory regulation

Super stealth dicing of transparent solids with nanometric precision

Precision Layered Stealth Dicing of SiC Wafers by Ultrafast Lasers

Biomimetic sapphire windows enabled by inside-out femtosecond laser deep-scribing

Orthogonal experimental study on the influence of machining parameters on flat lapping of sapphire substrate

High-quality micro/nano structures of 4H-SiC patterning by vector femtosecond laser

Research on sapphire micro-blind-hole machining based on femtosecond laser

Atomic Step Morphology Research of LED Sapphire Substrate Polishing Surface and Its Periodicity

Piezoelectric Ultrasonic Local Resonant Ultra-Precision Grinding for Hard–Brittle Materials

Thermal and optical properties of the femtosecond-laser-structured and stress-induced birefringent regions in sapphire