In Situ Electron Backscatter Diffraction Study of Deformation Inhomogeneity under Uniaxial Tension of Laser Melting Deposited TA15 Alloy

Muhammad Rizwan,Junxia Lu,Rafi Ullah,Wang Jin,Yuefei Zhang,Ze Zhang

DOI: https://doi.org/10.1007/s11665-024-10092-7

IF: 2.3

2024-09-22

Journal of Materials Engineering and Performance

Abstract:The discourse of the anisotropic mechanical properties of a unit-built additively manufactured component depends on its microstructural features and inhomogeneous distribution. This work explores the microstructure distribution and deformation inhomogeneity during uniaxial tension of a laser melting deposited TA15 near- α titanium alloy via advanced in situ secondary electron microscopy and electron backscattered diffraction characterization. Microscopically, two major regions can be distinguished in the overall microstructure, including a Widmanstätten (αw) region along the prior β -grain boundary (GB) and a basketweave-α region within the columnar grains. These two different microstructural regions responded differently under the same tensile load conditions. In the early deformation stage, only conventional slip occurred in the basketweave-α region, whereas microscale shear bandings developed in both the basketweave- α and α w regions. As the deformation progressed, the strain was optimally accommodated by the basketweave- α region. Nevertheless, the largest strain accumulation occurred along the prior β -GB because of a high misorientation angle, which resulted in the formation of cracks. Subsequently, the growth and propagation of the cracks along the prior β -GB were relatively fast due to the weak obstruction caused by the low angle of misorientation in the α w region, resulting in early fracture of the sample.

materials science, multidisciplinary