Ex-situ study on mechanical properties and deformation mechanism of three typical microstructures in TA19 titanium alloy

Yu Zhou,Ke Wang,Zhibing Yan,Renlong Xin,Shizhong Wei,Xiaodong Wang,Qing Liu
DOI: https://doi.org/10.1016/j.matchar.2020.110521
IF: 4.537
2020-09-01
Materials Characterization
Abstract:<p>The near-α titanium alloy TA19 with three typical microstructures (lamellar, equaixed and bimodal microstructure) were compressed, accompanied by ex-situ observation on the slip trace and crack nucleation, which aimed to reveal the dependence of mechanical properties on microstructure based on analyzing the deformation mechanism. The results revealed that the lamellar microstructure had the lowest yield strength because of very large colony size. Meanwhile, although the equiaxed α grain size in equiaxed microstructure was similar to the size of equiaxed α grain and α colony in the bimodal microstructure, the strengthening effect of α/β interface in α colony made the bimodal microstructure possess the highest yield strength. The fracture strain was strongly influenced by the crack nucleation and propagation in different microstructures. It was found that the largest α colony size induced an earliest crack nucleation and easy crack propagation in the lamellar microstructure, and then resulted in the smallest fracture strain. Conversely, the small size of α grain and colony induced a higher fracture strain in the equiaxed and bimodal microstructure. Furthermore, the intergranular β phase could coordinate the deformation between the two adjacent α grains and benefit the fracture strain in the equiaxed microstructure.</p>
materials science, multidisciplinary,metallurgy & metallurgical engineering, characterization & testing
What problem does this paper attempt to address?