Effect of Different Filler Wires on Mechanical Property and Conductivity of Aluminum-Copper Joints

Hengming Zhang,Yu Shi,Yufen Gu,Chunkai Li
DOI: https://doi.org/10.3390/ma13163648
IF: 3.4
2020-08-18
Materials
Abstract:The 1060 aluminum and T2 copper were joined by the pulsed double electrode gas metal arc welding (DE-GMAW) brazing method by using four types of filler wires, namely pure aluminum (Al) ER1100, aluminum-magnesium (Al–Mg) ER5356, aluminum-silicon (Al–Si) ER4043, and Al–Si ER4047, respectively. The effects of different types of filler wires on intermetallic compounds, microhardness tensile strength, and conductivity of joints were investigated. The results showed that a lot of brittle intermetallic compounds laying in the copper side brazing interface zone were generated using pure Al, Al–Mg, and Al–Si filler wires, which caused the change of microhardness, tensile strength, and the conductivity of joints. Meanwhile, with the increase in Si elements contents for Al–Sifiller wires, the thickness of the intermetallic compound layers decreased obviously, which was only up to 3 μm and the conductivity of the joints decreased. In addition, the microhardness, tensile strength, and the conductivity of the joints, when using Al–Sifiller wires, was higher than that using pure Al and Al–Mg filler wires. Hence, in comparison to the pure filler wires and Al–Mg filler wires, the Al–Si filler wires were more suitable for Al–Cu joints by DE-GMAW as Si element content was lower.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the influence of different filler wires on the mechanical properties and electrical conductivity of welded joints in the joining of aluminum - copper dissimilar materials. Specifically, the research objective is to explore the influence mechanisms of different filler wires on intermetallic compounds, micro - hardness, tensile strength and electrical conductivity in aluminum - copper joints by using four different filler wires (pure aluminum ER1100, aluminum - magnesium ER5356, aluminum - silicon ER4043 and aluminum - silicon ER4047) and adopting the pulsed double - electrode gas metal arc welding (DE - GMAW) brazing method. This helps to guide the selection of different filler wires suitable for aluminum - copper joints, especially when considering the optimization of mechanical properties and electrical conductivity. The paper analyzes the influence of different filler wires on the joint microstructure, mechanical properties and electrical conductivity through experiments, aiming to find the mechanism of the influence of alloy elements on the mechanical properties and electrical conductivity of aluminum - copper joints, so as to provide theoretical basis and technical support for the selection of appropriate filler wires.