Abstract:Aluminum–steel joints are increasingly used in the automotive industry to meet the requirements for energy saving and emission reduction. Among various joining technologies, self-pierce riveting (SPR) and resistance spot welding (RSW) are two well-established technologies for fabricating dissimilar joints with stable and high mechanical performance. However, corrosion will occur in these joints inevitably due to different electrochemical properties, which can degrade the surface quality and the mechanical performance, such as strength. This paper presents a method of understanding the corrosion mechanisms in joining aluminum and steel. For this understanding, a hybrid method combining experimental observations, mechanical properties identification, and analytical approaches was used to assess the evolution of the impact of corrosion on the joining performance, such as traction separation curves. The study was conducted on common combinations used in the vehicles, e.g., a 1.2 mm thickness aluminum alloy (AA 6022) and 2.0 mm thickness hot deep galvanized steel (HDG HSLA 340) joined by SPR and RSW. After the fabrication of these joints, accelerated cyclic corrosion tests of up to 104 cycles were performed, which reproduced the environmental conditions to which a vehicle was exposed. By investigating the microstructural evolution within the joints, the corrosion mechanisms of SPR and RSW joints were revealed, including the initiation and propagation. Moreover, the intrinsic impact of the corrosion on the mechanical performance, including the strength, axial stiffness, and crashworthiness, was analyzed by performing a lap-shear test. It showed that as corrosion proceeds, the fracture modes and mechanical performance are affected significantly.

Corrosion Behavior of Aluminum-Steel Weld-Brazing Joint

The Corrosion Resistance of 0cr19ni9 Stainless Steel Arc Welding Joints with and Without Arc Surface Melting

Corrosion Performance and Mechanical Strength in Aluminum 6061 Joints by Pulsed Gas Metal Arc Welding

Corrosion Behavior and Mechanical Property of 5182 Aluminum/DP780 Steel Resistance Spot Welding Joints

A novel corrosion transformation process in aluminum alloy / galvanized steel welded joint

The microstructure-corrosion relationships in laser-welded dissimilar steel-to-aluminium joints

Microstructure and Mechanical Properties of Pulsed Laser Welded Al/steel Dissimilar Joint

Effect of Heat Input on the Microstructure and Mechanical Properties of 6060 Aluminum Alloy/Galvanized STEEL MIG Welding–Brazing Joints

Influence of Alloy Elements on Microstructure and Mechanical Properties of Al/steel Dissimilar Joint by Laser Welding/brazing

Evaluation of Corrosion and Its Impact on the Mechanical Performance of Al–Steel Joints

Effects of Si contents in filling wires on microstructure evolution and properties of Al-steel dissimilar joint by laser welding-brazing

Effect of Al-Si Coating on the Interfacial Microstructure and Corrosion Resistance of Dissimilar Laser Al Alloy/22MnB5 Steel Joints

Phase analysis and corrosion behavior of brazing Cu/Al dissimilar metal joint with BAl88Si filler metal

Mechanical properties and corrosion resistance study of dissimilar metal thin sheet friction stir welded joints

Characteristics of TIG arc-assisted laser welding–brazing joint of aluminum to galvanized steel with preset filler powder

Corrosion Behavior of Joints of Mg-alloy AZ31 Fabricated by Friction Stir Welding

Experimental and numerical assessment of interfacial microstructure evolution in dissimilar Al/steel joint by diode laser welding-brazing

Corrosion Behavior of Metal Active Gas Welded Joints of a High-Strength Steel for Automotive Application

Effect of Different Filler Wires on Mechanical Property and Conductivity of Aluminum-Copper Joints

Laser–arc hybrid welding of high-strength steel and aluminum alloy joints with brass filler