Abstract:Trucking is a key industry in Canada with around 180 000 professional drivers. As an industry it has a disproportionately high injury claim rate, particularly for back injuries. Whole-body vibration (WBV) can contribute to the onset and development of low back disorders, and is a well-documented exposure among driving professions. A widely adopted WBV mitigation measure focuses on hydraulic and/or pneumatic passive suspension systems both in the driver's seat and underneath the vehicle cab. Passive suspension 'air-ride' seats are the current industry standard but new technologies such as the electromagnetic active vibration cancelling (EAVC) seats offer potentially substantial improvements in WBV reduction. In this paper, we evaluate and compare four commonly used truck seats (three air-ride, one EAVC) for their vibration damping characteristics and WBV exposure attenuation in on- and off-road conditions. We recruited 24 professional truck drivers who drove 280 km (mixed on-road and off-road) in ore-haul trucks under four different seating conditions. Following the ISO 2631-1 WBV standard, vibration measurements were made on the cab floor and seat pad, and 8-h average weighted vibration (A(8)) and 8-h vibration dose values (VDV(8)) were calculated, as well as the Seat Effective Amplitude Transmissibility (SEAT), and daily vibration action limits (DVALs). These measures were compared between seat types, as well as road conditions. The EAVC seat gave best performance for both A(8) (0.27 m s-2) and VDV(8) (6.6 m s-1.75). The EVAC seat had the lowest SEAT tested (36.2%) and the longest DVAL. However, among the three passive air-suspension seats, two showed significantly reduced A(8) (0.43 and 0.44 m s-2) and VDV(8) (9.1 and 9.3 m s-1.75) exposures relative to the third passive air-suspension seats [A(8) (0.54 m s-2) and VDV(8) (11.1 m s-1.75)]. These differences in exposures among the three passive air-suspension seats resulted in varying DVAL times, with the worst performing seat reaching the DVAL after only 6.3 h of driving. There was also a seat by road type interaction; there were performance differences between the passive air-suspension seats on-road, but not off-road. The observed reduction of the WBV exposures measured from the EAVC seat was consistent with previous results. But we showed that there can also be substantive differences among seats that are the current industry standard. These differences were more evident on-road than off-road, which suggests that more work needs to be done to understand seat performance characteristics, and in matching the correct seat technology to the driving task. We demonstrated that WBV exposures in current industry conditions may exceed health-based exposure limits; this has policy relevance because WBV exposures are linked to prevalent and costly adverse health conditions in a working population that is ageing. Increased WBV measurement collection is recommended to ensure the anticipated exposure attenuations are achieved when seats are relied upon as an engineered control against WBV.

Development and Flight Demonstration of an Active Seat Mount System for Aircrew Whole-Body Vibration Mitigation on NRC Bell-412 Helicopter

Model-Free Adaptive Control of an Active Half-Vehicle-Seat System Coupled with a Nonlinear Energy Sink Inerter (NESI)

Evaluation of the vibration transmitted to pilot’s body parts to determine the contribution of different design parameters in deficiency of available seats

Smart whole-body vibration attenuation, cushion for heavy equipment seating: Model and simulation

Amplified Pilot Head Vibration and the Effects of Vibration Mitigation on Neck Muscle Strain

The effects of whole-body vibration and head supported mass on performance and muscular demand

Active vibration reductions for airframe and human body of UH-60A helicopter in low- and high-speed flights

Evaluation of vertical and multi-axial suspension seats for reducing vertical-dominant and multi-axial whole body vibration and associated neck and low back joint torque and muscle activity

Whole-body Vibration Exposure Intervention among Professional Bus and Truck Drivers: A Laboratory Evaluation of Seat-suspension Designs

Seat vibration in military propeller aircraft: characterization, exposure assessment, and mitigation

The effects of different seat suspension types on occupants' physiologic responses and task performance: implications for autonomous and conventional vehicles

Individual Blade Control Approach for Active Vibration Suppression of a Lift-Offset Coaxial Rotorcraft

Multi-dimensional vibration isolating properties of a 3-RPS parallel damping seat

Exposure to Whole-Body Vibration in Commercial Heavy-Truck Driving in On- and Off-Road Conditions: Effect of Seat Choice

Multibody dynamics analysis of the human upper body for rotorcraft–pilot interaction

Three-axial evaluation of whole-body vibration in agricultural telehandlers: The effects of an active cab-suspension system

Vertical-dominant and multi-axial vibration associated with heavy vehicle operation: Effects on dynamic postural control

Vibration analysis of human body under seating posture: an automobile application

Vibration Effects of the Fixed-Wing Aircraft of the Army Aviation from Ecuador on the Human Body

Development of a High-Performance Low-Weight Hydraulic Damper for Active Vibration Control of the Main Rotor on Helicopters—Part 1: Design and Mathematical Model

Feasibility and Effectiveness of a Higher Harmonic Control System for a Medium Utility Helicopter