Abstract:Low-frequency vibration and blade track spread caused by non-uniform mass and aerodynamic distributions in the main rotor system may affect pilot’s health and shorten the life span of helicopter components. To eliminate these hazards, the manual passive maintenance procedure on the ground is adopted, but it is typically complex, time-consuming, and expensive; and the other existing active control algorithms do not simultaneously minimize the once-per-revolution (1/rev) vibration and blade track spread with complicated parameter tuning. In this work, a constrained optimal tuning (COT) method, is proposed to suppress both rotor 1/rev vibration and blade track spread utilizing pitch rod lengths as the control inputs. The COT method defines a constrained vibration control formulation, and it takes the track and the stroke range of pitch rods as a control constraint to ensure that the track spread is within specification and that the control inputs have no effect on the rotor’s performance. Moreover, the optimality and stability of the COT are mathematically proven. The numerical simulations about non-uniform rotor were performed successfully utilizing the established main rotor dynamic model. The results show that the 1/rev vibration in the X, Y, and Z directions can all be decreased by more than 90 %, and the track spread can be reduced by more than 80 %. The introduction of input constraints maintains the control safety while also easing the burden of parameter tuning. Meanwhile, the 2/rev components of the lateral forces are similarly reduced. Furthermore, the control algorithm is modeled in software and built into real-time code to verify its effectiveness through the wind tunnel experiments. The experimental results reveal that 1/rev vibration is effectively reduced in three directions. The proposed controller also improves the aerodynamic environment of the blades, reducing almost all strange harmonic components (n-0.5)/rev (n = 1 to 10) to near zero.

Feasibility and Effectiveness of a Higher Harmonic Control System for a Medium Utility Helicopter

Simultaneous Vibration Reduction and Performance Improvement of Helicopter Rotor Using Individual Blade Pitch Control with Multiple Harmonic Inputs

Design and Hover Test of Low Vibration Mach Scale Rotor with Twisted Composite Tailored Blade

Individual Blade Control Approach for Active Vibration Suppression of a Lift-Offset Coaxial Rotorcraft

Individual Blade Control for Component Load Alleviation Using Higher-Order Linear Time-Invariant Models

Experimental Study on the Vibration Control Capability of a Hybrid Squeeze Film Damper

An excellent harmonic feedforward-sliding mode output feedback hybrid algorithm for helicopter active vibration control

Active vibration reductions for airframe and human body of UH-60A helicopter in low- and high-speed flights

Experimental investigations on active control of multifrequency helicopter vibrations using discrete model predictive sliding mode control

Active vibration control based on linear matrix inequality for rotor system under seismic excitation

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Dynamical Behaviors of Hybrid Squeeze Film Damper for Rotor System Vibration Control

A novel constrained optimal tuning method with application to helicopter rotor track and balance

Investigation of Rotor Control System Loads

Active and Passive Helicopter Noise Reduction Using the AVINOR/HELINOIR Code Suite

Tilt-rotor aircraft fuselage wall aeroacoustics radiation suppression using Higher harmonic control

Design and test of adaptive torsional vibration suppression method for helicopter power system with variable rotor speed

A Hybrid Control Method for an Unmanned Scale Helicopter Attitude

Nonlinear dynamic of turbulent bearing-rotor system under quadratic damping with HSFD and active control

Development of Swashplateless Helicopter Blade Pitch Control System Using the Limited Angle Direct-Drive Motor (LADDM)

Rotor Power Savings and Pitch-Link Load Reductions with Spanwise-Varying Active Camber Morphing