Abstract:This paper addresses the acoustic and aerodynamic characteristics of small rotor configurations, including the influence of the rotor–rotor interactions. For this purpose, a Rotor/Rotor/Pylon configuration is chosen for both the test and numerical simulations. The wind tunnel experiments on various rotor configuration were performed in DLR's Acoustic Wind Tunnel Braunschweig (AWB). The experiments involve isolated rotors, and rotors in tandem and coaxial configuration in hover and forward flight. For numerical simulations, an unsteady free wake 3D panel method (UPM) is used to account for aerodynamic non-linear effects associated with the mutual interference among the Rotor/Rotor/Pylon configurations. The effect of the pylon is simulated using potential theory in form of a panelized body. Finally, the sound propagation into the far field is calculated with DLR's FW–H code APSIM, using UPM blade surface pressure as input. The validation effort is supported by CFD TAU steady simulations on selected hover test cases. The experiments and numerical results indicate that the noise at the blade passing frequency (BPF) and its higher harmonics is the dominant source of the noise for the present rotor selection. The extra subharmonics between two BPFs appearing in the results are caused by the small geometric discrepancy between the blades as well as the motor noise. Broadband noise is also observed in the experiment, but its contribution to the overall sound pressure is very small and can be neglected. The simulation of the acoustic scattering from the rotor support system for the isolated rotor cases indicated an influence about 1–3 dB on the overall sound pressure of the polar microphones. In both the coaxial and the tandem configuration, the acoustic interferences are particularly well visible in the numerical simulations and cause a more complex noise directivity. There is almost no change in time-averaged inflow by applying phase angles. In the coaxial condition, in hover, the phase delay between rotors does not change the maximum noise level. In forward flight, the phase delay can influence the maximum level of the noise radiation. In both coaxial and tandem configuration, the position of the downstream rotor is key for the noise radiation, and therefore, avoiding the interaction with upstream wake can reduce the noise radiation.

Active and Passive Helicopter Noise Reduction Using the AVINOR/HELINOIR Code Suite

Numerical study of potential application of active suction and blowing through blade tip perforation to reduction of helicopter rotor thickness noise

Aeroacoustic modeling of helicopter transonic rotor noise

An Experimental Study on Rotor Aerodynamic Noise Control Based on Active Flap Control

A global rotor noise control method based on near-field acoustic holography and sound field reproduction

Aeroacoustic and aerodynamic measurements at the rotor plane in the interaction of a small rotor with wings

Experimental study on noise reduction of a wavy multi-copter rotor

Rotorcraft Flight Control Design for Rotor Noise Abatement

A new blade tip geometry to improve aerodynamic performance and acoustic noise of helicopter blade in hovering flight

Transonic Hovering Rotor Aeroacoustic Predictions Using Navier-Stokes/Kirchhoff Method

Numerical studies on small rotor configurations with validation using acoustic wind tunnel data

Tilt-rotor aircraft fuselage wall aeroacoustics radiation suppression using Higher harmonic control

Numerical investigation on the use of various blade tips for the helicopter's main rotor blade in forward flight regarding aerodynamic performance and HSI noise considerations

An Experimental Study of Noise Generated by Tandem Blades

Noise generated by a helicopter rotor

Development and validation of a hybrid method for predicting helicopter rotor impulsive noise

Noise reduction and aerodynamics of isolated multi-copter rotors with serrated trailing edges during forward flight

VIBROACOUSTIC SOUNDPROOFING FOR HELICOPTER INTERIOR

Rotor noise in non-axial inflow conditions

Simultaneous Vibration Reduction and Performance Improvement of Helicopter Rotor Using Individual Blade Pitch Control with Multiple Harmonic Inputs

Feasibility and Effectiveness of a Higher Harmonic Control System for a Medium Utility Helicopter