Abstract:The aerodynamic performance of a reduced-scale coaxial rigid rotor system in hover and steady forward flights was experimentally investigated to gain insights into the effect of interference between upper and lower rotors and the influences of the advance ratio, shaft tilt angle and lift offset. The rotor system featured by 2 m-diameter, four-bladed upper and lower hingeless rotors and was installed in a coaxial rotor test rig. Experiments were conducted in the Φ3.2 m wind tunnel at China Aerodynamics Research and Development Center (CARDC). The rotor system was tested in hover states at collective pitches ranging from 0° to 13° and it was also tested in forward flights at advance ratios up to 0.6, with specific focus on the shaft tilt angle and lift offset sweeps. To ensure that the coaxial rotor was operating in a similar manner to that of the real flight, the torque difference was trimmed to zero in hover flight, whilst the constant lift coefficient was maintained in forward flight. An isolated single-rotor configuration test was also conducted with the same pitch angle setting in the coaxial rotor. The hover test results demonstrate that the figure of merit (FM) value of the lower rotor is lower than that of the upper rotor, and both are lower than that of the isolated single rotor. Moreover, the coaxial rotor configuration can contribute to better hover efficiency under the same blade loading coefficient (CT/σ). In forward flight, the effective lift-to-drag (L/De) ratio of the coaxial rigid rotor does not monotonously change as the advance ratio increases. Increases in the required power and drag in the case with a high advance ratio of 0.6 leads to the decreasing L/De ratio of the rotor. Meanwhile, the L/De ratio of the rotor is relatively high when the rotor shaft is tilted backward. The increasing lift offset tends to result in reduced required rotor power and an increase in the rotor drag. When the effect of the reduced rotor power is greater than that of the increased rotor drag, the L/De ratio increases as the lift offset increases. The L/De ratio can benefit significantly from lift offset at a high advance ratio, but it is much less influenced by lift offset at a low advance ratio. The forward performance efficiency of the upper rotor is poorer than that of the lower rotor, which is significantly different from the case in the hover flight.

Rotor Power Savings and Pitch-Link Load Reductions with Spanwise-Varying Active Camber Morphing

Design and Hover Test of Low Vibration Mach Scale Rotor with Twisted Composite Tailored Blade

Development of Mach Scale Rotors with Tailored Composite Coupling for Vibration Reduction

Mission-based optimal morphing parameters for rotors with combined chord and twist morphing

Resonant passive energy balancing of morphing helicopter blades with bend–twist coupling

Influence of differential longitudinal cyclic pitch on flight dynamics of coaxial compound helicopter

Load prediction of hingeless helicopter rotors including drivetrain dynamics

Control of Reverse Flow over Cantilevered Swept Blades Using Passive Camber Morphing

Simultaneous Vibration Reduction and Performance Improvement of Helicopter Rotor Using Individual Blade Pitch Control with Multiple Harmonic Inputs

Use of segmented constrained layer damping treatment for improved helicopter aeromechanical stability

Aerodynamic Performance of a Hovering Cycloidal Rotor: A CFD Study with Experimental Validation

Investigation of Rotor Control System Loads

Numerical Investigation of an NACA 13112 Morphing Airfoil

Wind Tunnel Studies on Hover and Forward Flight Performances of a Coaxial Rigid Rotor

Model and experimental analysis of a rotor rig dynamics with time-varying characteristics

Study On The Mechanism Of The Variable-Speed Rotor Affecting Rotor Aerodynamic Performance

Aeroelastic model and analysis of an active camber morphing wing

Influence of Blade Geometric Parameters on Aeroelastic Response of a Helicopter Rotor System

Low-Order Modeling of Stacked Rotor Performance in Hover

Effects of blade configuration parameters on helicopter rotor structural dynamics and whirl tower loads

Prediction of Rotor Structural Loads with Comprehensive Analysis