Abstract:The IGZO (InGaZnO)-based two-transistor zero-capacitor(2T0C) DRAM has attracted much attention as an alternative memory to overcome the scale-down limit of current 1T1C DRAM due to its low power consumption and monolithic 3D stacking capability. In particular, its low power consumption and the feasibility of low temperature process make it highly implementable for 3D DRAM. For operating the 2T0C DRAM, four metal lines are necessary, i.e., write word line and write bit line (WBL) for operating write transistor (WTR), and read word line and read bit line (RBL) for operating read transistor (RTR). In this study, we propose a 3-terminal 2T0C DRAM to enhance its memory characteristics, where RBL was combined with WBL, enabling 2T0C memory operation with only three metal lines as shown in Fig. 1(b). In addition, we investigated the dependency of retenetion time of the proposed 2T0C DRAM on channel length. In particular we evaluated the dependency of the sneak current of 2T0C DRAM on off-current of transistor. For the fabrication of 3-terminal IGZO 2T0C DRAM, a top gate IGZO transistor was fabricated using RF sputtering and two transistors were connected by storage node and bit line bridge as shown in Fig. 1(d).The storage node was formed by connecting the gate of RTR to drain of WTR. And source electrodes of both transistors were coupled. To determine the voltage values for memory operation, the transfer curve of each transistor was characterized and the threshold voltages for both RTR and WTR were around 1 V. The write and read voltages were set to 3 and 2 V, respectively. The retention time was measured by performing periodic read operations after writing and measuring the RTR currents. In addition, the retention time of transistors for varying channel length and gate capacitance was characterized. The retention time was defined as the time to be taken for decreasing the currents by 90 %. Furthermore, the disturbance of 2T0C DRAM with 2x2 array structure was investigated. The RTR currents of selected cells were measured depending on the memory state of adjacent cells. It was found that the retention times of transistors with 10- and 100-um RTR channel lengths were approximately 15 and 30 seconds, respectively. It was observed that the memory state was not changed from “0“ to “1“ by disturbant currents, but, RTR currents of “0“ state cell increased slightly when an adjacent cell was turned on. However, as shown in Fig.1(i) and (j), when off-currents of transistor of 2T0C DRAM decreased from 20 nA to 200 pA, it was confirmed the sneak current of 2T0C decreased. Finally, several technical apporaches how to suppress the disturbant currents will be presented in detail. Acknowledgement This research was supported by BrainKorea21 Four. Figure 1

D2D Variation Aware DTCO for Novel Vertical A-Igzo-fets in Large-Scale M3D 2TOC DRAM Bit Cell Evaluation Via Statistical Modeling Methodology

Computational Associative Memory with Amorphous Metal‐Oxide Channel 3D NAND‐Compatible Floating‐Gate Transistors

A design methodology for highly reliable operation for 2T0C DRAM application based on IGZO CAA FeFETs

A Dual Core Oxide 8T SRAM Cell with Low Vccmin and Dual Voltage Supplies in 45nm Triple Gate Oxide and Multi Vt CMOS for Very High Performance Yet Low Leakage Mobile SoC Applications

Design Technology Co-Optimization for the DRAM Cell Structure With Contact Resistance Variation

Variation-aware analysis of buried-channel-array transistors (BCATs) in scaled DRAM: insights from 3D quasi-atomistic simulations

First Experimental Demonstration of 3D-Stacked 2T0C DRAM Cells Based on Indium Tin Oxide Channel

3D-Stacked 2T0C-DRAM Cells Using Al2O3/TiO2-Based 2DEG FETs

Investigation of Asymmetric Characteristics of Novel Vertical Channel-All-Around (CAA) In-Ga-Zn-O Field Effect Transistors

A Novel Capacitorless 1T DRAM with Embedded Oxide Layer

Vertical Surrounding Gate Transistor for High Density and Low Voltage Operation in DRAM

Modeling the Thermal Characteristics of Stacked 2T0C Memory Array Based on InGaZnO4 Thin-Film Transistors

Capacitorless DRAM Cells Based on High-Performance Indium-Tin-Oxide Transistors with Record Data Retention and Reduced Write Latency

3-Terminal Igzo FET Based 2T0C DRAM Combined Bit-Line Structure

High Performance 2T0C DRAM Cells Based on Atomic-Layer-deposited InAlZnO FETs

30 Mb/mm<sup>2</sup>/layer 3D eDRAM Computing-in-Memory with Embedded BEOL Peripherals and Local Layer-wise Calibration based on First-Demonstrated Vertically-stacked CAA-IGZO 4F<sup>2</sup> 2T0C Cell

Direct Observation for Distinct Behaviors of Gamma‐Ray Irradiation‐Induced Subgap Density‐of‐States in Amorphous InGaZnO TFTs by Multiple‐Wavelength Light Source

Analysis of electrostatic crosstalk in 3D vertical NAND Charge Trapping Memory with junctionless GAA nanowire FET

Computational Associative Memory with Amorphous InGaZnO Channel 3D NAND-Compatible FG Transistors

The Programming Optimization of Capacitorless 1T DRAM Based on the Dual-Gate TFET

A Cross-Process Signal Integrity Analysis (CPSIA) Method and Design Optimization for Wafer-on-Wafer Stacked DRAM