Abstract:Atomic layer deposited TiN thin films on SiO2/Si for Through Silicon Via applications were investigated in this paper. TiCl4 and NH3 were used as the source and reactant gases, respectively. The thin films were deposited at the temperature range between 350 degrees C and 500 degrees C.Difference analysis methods, including AES, XRD, four-point probe and ellipsometer were employed to evaluate the properties of deposited TiN films. The measured deposition rate of TiN films is about 0.15 angstrom/cycle, independent from the process condition, which indicates the growth mechanism of ALD. Resistivity of deposited thin films was measured by a four-point probe and the relationship between the resistivity and deposition temperature was investigated. Resistivity of the films is less than 125 mu Omega.cm when deposition temperature is above 400 degrees C, which decreases when the deposition temperature increases, as well as the film thickness. TiN film was grown with [100] preferred orientation at 350 degrees C, while with [111] preferred orientation at 400 degrees C and higher temperatures. Chemical composition was analyzed by AES, the content of chorine in TiN films is about 1.5 at. % at the deposition temperature of 350 degrees C, and it decrease to 0.5 at. % when the deposition temperature is above 350 degrees C.In order to investigate the performance of TiN as diffusion barrier layer, the structure of Cu/TiN/SiO2/Si was prepared. Annealing of the samples were performed in a vacuum ambient of 10(-5) Pa at selected temperatures for 1h. XRD analysis results indicate that no copper diffusion into the SiO2 for Si with Cu/TiN/SiO2 films after annealing below 500 degrees C.

Electroplating Cu on ALD $\text{tin}$ for Small Size TSV

Electroplating Cu on ALD TiN for high aspect ratio TSV

Study on the behaviors of Cu filling in special through-silicon-vias by the simulation of electric field distribution

Wet processes deposition for HAR TSV metallization using electroless Co liner and alkaline Cu seed layer

Novel Copper Filling Methods for 2 Μm × 20 Μm TSVs with an Electroless Deposited Co or Atomic Layer Deposited Ru Seed Layer

Atomic Layer Deposition Tin Barrier Layers For Through Silicon Via Applications

Cu electroplating chemistry and process enabling rapid TSV filling with long bath life

Discrete Study of ALD TaN on Via and Line for Low Resistive and High Reliable Cu/Low-k Interconnects and Other Applications

Electroless Cu Deposition Process on TiN for ULSI Interconnect Fabrication Via Pd/Sn Colloid Activation

Electroless Copper Deposition for Ultralarge-Scale Integration

Optimization of Cu electrodeposition parameters for Through Silicon Via (TSV)

Properties of TiN films deposited by atomic layer deposition for through silicon via applications

Copper Filling Process for Small Diameter, High Aspect Ratio Through Silicon Via (Tsv)

An ultra-deep TSV technique enabled by the dual catalysis-based electroless plating of combined barrier and seed layers

ALD TaN Barrier for Enhanced Performance with Low Contact Resistance for 14nm Technology Node Cu Interconnects

Deposition of TiN and TaN by Remote Plasma ALD for Cu and Li Diffusion Barrier Applications

Fully back-end TSV process by Cu electro-less plating for 3D smart sensor systems

Recent Advances in Barrier Layer of Cu Interconnects

Pure Bottom-up filling process for efficient TSV metallization

Investigation of a Single-Component Additive for Bottom-Up Superfilling of the High-Aspect-Ratio TSV by Theoretical and Experimental Studies

ALD-grown Seed Layers for Electrochemical Copper Deposition Integrated with Different Diffusion Barrier Systems