Abstract:In vessel retention (IVR) is one of the key severe accident mitigation strategies to maintain reactor pressure vessel (RPV) integrity. IVR designs utilize the reactor pressure vessel lower head to contain molten fuel and rely on external reactor vessel cooling (ERVC) to remove decay heat. The capacity of ERVC is limited by the critical heat flux (CHF) of flow boiling on the outside of the reactor vessel surface. Therefore, the determination of critical heat flux (CHF) is crucial to predict whether the adoption of IVR would be successful in mitigating severe accidents. In 1999, Celeta et.al proposed a superheated layer vapor replenishment model. In this model they postulated that CHF would occur when the superheated layer was occupied by the vapor blanket coming into contact with the heated wall and they successfully predicted the critical heat flux in subcooled water flow boiling under high mass flux, high liquid subcooling and low/medium pressure conditions. To evaluate the practicability of this model in predicting CHF under IVR conditions, CHF experiments were performed under natural circulation conditions on the experiment facility "Test of External Vessel Surface with Enhanced Cooling" (TESEC). Experiments are conducted in a 30 mm wide, 61mm high rectangular flow channel with a 200 mm long heated surface along the flow direction. Two quartz windows are installed at the sidewalls of the flow channel for visualization. In order to simulate various positions of the reactor lower head, experiments at different inclination angles of the test section were conducted. The high speed visualization data at CHF point at various inclination angles were processed and analyzed by a MATLAB code developed by the author. The vapor blanket thickness at various inclination angles was measured from the visualization data and was also predicted by the Celeta model. By using geometry data from high speed images, CHF values were calculated by Celeta model and compared with the experimental results at various inclination angles. Limitations of the Celeta model in adaptation of predicting CHF under IVR conditions were further discussed.

The Safety Criteria of High Flux Research Reactor with Downward Parallel Channels: Onset of Flow Instability and Critical Heat Flux

STUDY ON THE RELATIONSHIP BETWEEN CRITICAL HEAT FLUX PREDICTED BY SUDO93 CORRELATION AND ONSET OF FLOW INSTABILITY IN DOWNFLOW SYSTEMS

A CHF Correlation and Flow Pattern Observation on a Downward-Facing Boiling Surface

Frictional Resistance Investigation of Sco2 and a Semi-Empirical Friction Factor Correlation Based on Wall-of-the-law

An Empirical Correlation for the Entrainment Fraction at the Onset of Annular Flow Based on 2006 Chf Look-Up Table

Design and Evaluation of Mitigation Measures for Tsinghua High Flux Reactor Loss-of-Coolant Accidents

Evaluation of Passive Circulation Flow Characteristics and Chf under In-Vessel Retention

Prediction of “critical heat flux” for supercritical water and CO2 flowing upward in vertical heated tubes

Subchannel Analysis of Critical Heat Flux in Radially Non-Uniform Heated Rod Assembly at Low Flow Rate

A Critical Heat Flux Model for Saturated Flow Boiling on the Downward Curved Heated Surface

An experimental study of the CHF in a square channel with non-uniformly heated rod under low pressure and low flow conditions

Prediction of Flow and Temperature Distributions in a High Flux Research Reactor Using the Porous Media Approach

Separate factors’ effects on CHF for flow boiling in an inclined rectangular channel under low mass flux

CFD study on flow-boiling characteristics and predicting critical heat flux under natural circulation conditions of IVR-ERVC

Direct Numerical Simulation of Turbulent Free-Surface High Prandtl Number Fluid Flows in Fusion Reactors

Study on the Prediction of DNB-Type Critical Heat Flux in Rod Bundle Under Motion Conditions

Prediction Of subcooled water flow boiling critical heat flux (CHF) at low pressure

Prediction of Critical Heat Flux for Subcooled Flow Boiling in Annulus and Transient Surface Temperature Change at CHF

Flow thermohydraulic characterization of open diverging microchannel heat sink for high heat flux dissipation

Theoretical model for subcooled upward flow boiling heat transfer and critical heat flux for an inclined downward heated surface

OpenFOAM CFD simulation of critical heat flux in vertical pipe under typically PWR conditions