Abstract:The preparation of β-hemihydrate gypsum is an important approach for large-scale utilization of phosphogypsum (PG) because of the simple production technology by calcination. However, the dehydration behaviour and impurity change during the transformation of PG to β-hemihydrate gypsum at low temperatures are unclear. In this study, the dehydration of PG at different temperatures was investigated by a calcination test and in-situ X-ray diffraction analysis. The variation in crystal morphology and structure of PG was clarified using scanning electron microscopy and Materials Studio software. Furthermore, the change of impurity was analyzed by energy-dispersive spectroscopy, Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy measurements. The results show that the dehydration of PG to β-hemihydrate gypsum depends on calcination temperature and time. Moreover, an increase in the calcination temperature could accelerate the dehydration of PG and shorten the dehydration time; meanwhile increasing the calcination time or calcination temperature could make a part of β-hemihydrate gypsum further dehydrate to anhydrite. The morphology and elemental distribution of PG did not dramatically change during calcination, but the grain size decreased and the elemental distribution density increased. It should be noted that the calcination did not decrease the phosphorus and fluorine contents in PG at 120 °C, whereas the contents increased due to the removal of crystal water. The phosphorus impurity form transformed from CaHPO4·2H2O and Ca(H2PO4)2·H2O to CaHPO4 and Ca(H2PO4)2, respectively. Therefore, the calcination could not remove the phosphorus and fluorine from PG, and pretreatment is required to reduce the adverse effects of impurities in the industrial production of β-hemihydrate gypsum.

Recycling Industrial Byproduct Gypsum for Use As Plastering Materials by the Tandem Pyro-Hydro Process: Impurities Removal, Whiteness Improvement, and Regularity of Phase Evolution

Study on Mechanisms for Improving Quality and Whiteness of Phosphogypsum Based on Process Mineralogy Analysis

Simultaneous removal of phosphorus and organic contaminants from phosphogypsum using hydrothermal method for gypsum resource regeneration

Efficient precipitation of soluble phosphorus impurities in the recycling of phosphogypsum to produce hemihydrate gypsum

Flotation purification of waste high-silica phosphogypsum

Efficient removal of impurities from phosphogypsum during preparation of α-hemihydrate gypsum

The study on the effect of flotation purification on the performance of α-hemihydrate gypsum prepared from phosphogypsum

Dehydration behaviour and impurity change of phosphogypsum during calcination

Recycling of waste gypsum from αlpha-hemihydrate phosphogypsum: Based on the atmospheric hydrothermal process

A Novel Process to Recover Gypsum from Phosphogypsum

Preparation of gypsum with high purity and whiteness from phosphogypsum for CO2 mineral sequestration

Deep removal of phosphorus and synchronous preparation of high-strength gypsum from phosphogypsum by crystal modification in NaCl-HCl solutions

Efficient extraction of impurities from phosphogypsum during crystal regulation of α‐hemihydrate gypsum

Gradient removal of Si and P impurities from phosphogypsum and preparation of anhydrous calcium sulfate

Novel Synergistic Process of Impurities Extraction and Phophogypsum Crystallization Control in Wet-Process Phosphoric Acid

Retarding effect of impurities on the transformation kinetics of FGD gypsum to α-calcium sulfate hemihydrate under atmospheric and hydrothermal conditions

Characterisation of Purified Gypsum and Insoluble Impurities Obtained from Phosphogypsum Waste

Investigating the novel process for thorough removal of eutectic phosphate impurities from phosphogypsum

Characteristic pollutant purification analysis of modified phosphogypsum comprehensive utilization

Staged purification of phosphogypsum using pH-dependent separation process