Abstract:Phosphogypsum (PG) is a kind of industrial solid waste with high impurity content and low utilization rate. In this study, α-hemihydrate gypsum (α-HH) was synthesized from PG in H3PO4–H2O solution (wet-process phosphoric acid solution and phosphoric acid solution) under atmospheric pressure. The crystal morphology of α-HH was controlled by adding F and Al compound regulators, and the mechanical properties of α-HH were improved. The difference of α-HH synthesized by PG with different qualities was analyzed, and the mechanism of α-HH morphology was studied by X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and energy-dispersive spectroscopy (EDS). Results showed that in the wet-process phosphoric acid solution, α-HH synthesized from white PG (by H3PO4–H2SO4 two-step method) had better whiteness, purity, and mechanical properties compared with that from industrial PG, and the performance indexes of the α-HH products met the requirements of α50 grade in JC/T 2038–2010 α-high-strength gypsum in China and have a good commercial application prospect. Moreover, in the phosphoric acid solution, the average diameter of the α-HH crystal increased from 8.1 µm to 54.8 µm, the average aspect (L/D) ratio decreased from 32.65 to 0.52, and the induction period and growth period of the α-HH crystal were prolonged with the increase in regulator dosage. F− and Al3+ ions were preferred to adsorb on the crystal faces. The growth of the crystal parallel to c-axis (200), (020), and (400) was inhibited, and the morphology of the α-HH crystal changed from whisker to short column. When the dosage of the regulator was 1.1 %, the 2 h bending strength of the α-HH product was 6.56 MPa, and the drying compressive strength was 52.4 MPa. This study provides a new technique and method for the synthesis of high-strength α-HH products from PG.

Efficient removal of impurities from phosphogypsum during preparation of α-hemihydrate gypsum

Efficient extraction of impurities from phosphogypsum during crystal regulation of α‐hemihydrate gypsum

Deep removal of phosphorus and synchronous preparation of high-strength gypsum from phosphogypsum by crystal modification in NaCl-HCl solutions

Efficient precipitation of soluble phosphorus impurities in the recycling of phosphogypsum to produce hemihydrate gypsum

Synthesis of α-hemihydrate gypsum from cleaner phosphogypsum

Gradient removal of Si and P impurities from phosphogypsum and preparation of anhydrous calcium sulfate

Utilization of phosphogypsum to synthesize α-hemihydrate gypsum in H3PO4–H2O solution

Study on Strengthening the Crystallization Process of Removing F and P from Phosphogypsum Produced by Dihydrate–Hemihydrate Wet Process

Simultaneous removal of phosphorus and organic contaminants from phosphogypsum using hydrothermal method for gypsum resource regeneration

Novel Synergistic Process of Impurities Extraction and Phophogypsum Crystallization Control in Wet-Process Phosphoric Acid

Preparation of α-hemihydrate gypsum whiskers from phosphogypsum using atmospheric pressure nitrate solution

The study on the effect of flotation purification on the performance of α-hemihydrate gypsum prepared from phosphogypsum

Investigating the novel process for thorough removal of eutectic phosphate impurities from phosphogypsum

High-Efficiency Purification and Morphology Regulation of CaSO42H2O Crystals from Phosphogypsum

Moderately efficient leaching of rare earth elements from phosphogypsum via crystal regulation with EDTA-2Na during gypsum phase transformation and recovery by precipitation

Preparation of α-hemihydrate gypsum from phosphogypsum in glycerol and Na2SO4 mixed solutions under atmospheric pressure

Preparation of gypsum with high purity and whiteness from phosphogypsum for CO2 mineral sequestration

Staged purification of phosphogypsum using pH-dependent separation process

High-Efficiency Purification and Morphology Regulation of CaSO4·2H2O Crystals from Phosphogypsum

Promotion of Conversion Activity of Flue Gas Desulfurization Gypsum into Α-Hemihydrate Gypsum by Calcination-Hydration Treatment

Optimization of wet-process phosphoric acid for high-quality phosphogypsum