Abstract:Phosphogypsum (PG) is a solid waste generated during the wet production of phosphoric acid, noted for causing significant environmental pollution due to low pH and contamination with phosphorus-fluorine impurities. This work proposes an innovative method of acid treatment to acidify PG by directly adding of sulfuric acid at suitable temperatures. Initially, this acid treatment process is employed to convert and remove phosphorus-fluorine impurities, followed by PG after acid treatment incorporation with lime for safe solidification. The conversion mechanisms of phosphorus-fluorine impurities during acidification and solidification are elucidated. Results demonstrate that the direct acidification method converts most fluoride into H 2 SiF 6 and HF, which are subsequently released from the PG system after a temperature of 175 °C treatment. Phosphorus is wholly transformed into water-soluble forms (H 3 PO 4 /H 2 PO 4 - /HPO 4 2- ), especially as eutectic phosphorus is released and converted when CaSO 4 ·2 H 2 O crystals dissolve to II-CaSO 4 . Following acidification to achieve a high water-soluble phosphorus/fluorine ratio, lime is added to convert phosphorus-fluorine impurities into Ca 5 (PO 4 ) 3 F, ensuring harmlessness. The addition of 3.7 % lime to acidified PG, an acid amount of 2-times the theoretical requirement, yields a treatment solution with pH=8.65, ρ(P)=0.05 mg/L and ρ(F - )=1.11 mg/L, meeting Class V water discharge standards (GB 3838–2002). The solidified PG filter residue contains the water–soluble ω(P 2 O 5 ) ≤ 0.01 % and ω(F - ) ≤ 0.0061 %, suitable for safe storage. This work indicates that this process can separate phosphorus impurities with lower energy consumption, providing a harmless PG treatment. Furthermore, the treated PG can hydrate to gain strength, potentially enhancing its utility as a resource.

Gradient removal of Si and P impurities from phosphogypsum and preparation of anhydrous calcium sulfate

Deep removal of phosphorus and synchronous preparation of high-strength gypsum from phosphogypsum by crystal modification in NaCl-HCl solutions

Simultaneous removal of phosphorus and organic contaminants from phosphogypsum using hydrothermal method for gypsum resource regeneration

Efficient removal of impurities from phosphogypsum during preparation of α-hemihydrate gypsum

Efficient extraction of impurities from phosphogypsum during crystal regulation of α‐hemihydrate gypsum

Efficient precipitation of soluble phosphorus impurities in the recycling of phosphogypsum to produce hemihydrate gypsum

Staged purification of phosphogypsum using pH-dependent separation process

Preparation of gypsum with high purity and whiteness from phosphogypsum for CO2 mineral sequestration

Study on Mechanisms for Improving Quality and Whiteness of Phosphogypsum Based on Process Mineralogy Analysis

Research on the technology and mechanism of direct acidification of phosphogypsum and deeply solidify impurities with lime

Investigating the novel process for thorough removal of eutectic phosphate impurities from phosphogypsum

Recyclable and Efficient Recovery of Ca and S from Phosphogypsum by Using Multistep Precipitation

Flotation purification of waste high-silica phosphogypsum

Synthesis of α-hemihydrate gypsum from cleaner phosphogypsum

High-Efficiency Purification and Morphology Regulation of CaSO4·2H2O Crystals from Phosphogypsum

Preparation of Anhydrite from Phosphogypsum: Influence of Phosphorus and Fluorine Impurities on the Performances

Preparation of Calcium Sulfide by Sludge‐assisted Rice Husk Reduction of Phosphogypsum

Enhanced absorption of SO 2 from phosphogypsum decomposition by phosphate slurry for phosphoric acid production

Study on the Recycling of P in Phosphogypsum Leachate

Novel Synergistic Process of Impurities Extraction and Phophogypsum Crystallization Control in Wet-Process Phosphoric Acid

Simultaneous immobilizations of soluble phosphorus and fluorine in phosphogypsum by milling with calcareous and aluminiferous samples: Reaction products and immobilization performances