Abstract:With the continuous innovation and improvement of electronic information and systems, the transmission power in the equipment is also increasing. For the propagation of high-power microwaves, not only the transmission characteristics of high-power microwaves should be considered, but also the protection measures should be taken to prevent the damage caused by excessive pulses on the back-end equipment. In this article, the characteristics of waveguide plasma limiter are studied based on the plasma formed by low pressure microwave gas discharge, which reflects and absorbs electromagnetic waves. At the same time, in response to the potential power leakage problem of single-stage plasma limiters in protecting high-power microwaves, a protective device is proposed for the combination of plasma limiters and PIN limiters in rectangular waveguides. When the incident microwave intensity is strong, the electronic components are protected from burning by plasma. When the front-end plasma limiter fails to exert its effect and causes power leakage, the transmitted microwave energy is attenuated by the subsequent PIN diode limiter circuit, causing its strength to fall below the safety threshold. This limiter system model can be controlled and described by the electromagnetic (EM) fields, plasma physics and PIN equivalent circuit model. In the multi-physics cascaded waveguide limiter system, the spectral-element time-domain (SETD) method is used for system integration and self-consistent simulation analysis. The results show that the limiting performance of the cascaded limiter is much better than that of the single-stage plasma limiter under the action of HPM pulses. This research provides theoretical guidance for the use of plasma limiting devices to protect against high-power microwave damage.

Multiple Transient Voltage Suppressor Diodes-Based Protection Circuits with Decreasing Loading Effect under High-Power Microwave Pulses

Transient Voltage Suppressor Diode Array Protection Circuits with Reducing Loading Effect under High-Power Microwave Pulse Injection

Protection Effects Using Transient Voltage Suppressor Diodes Based Circuits under High-Power Microwave Pulses

Immunity Analysis and Experimental Investigation of a Low-Noise Amplifier Using a Transient Voltage Suppressor Diode under Direct Current Injection of HPM Pulses

Transient Characterization of Power Divider Response Illuminated by a High-Power EMP

Simulation of the Hpm Power and Pulse Width on the Influence of Esd Protection Device

Simulation Study on Novel High Voltage Transient Voltage Suppression Diodes

STUDY OF NONLINEAR EFFECT ON ELECTRONIC SYSTEM INDUCED BY TVS LIMITER WHEN ILLUMINATED BY HPEM PULSE

Research on High Power Output Characteristics of an Low-frequency Solid-state Protector

Novel Multifunctional Transient Voltage Suppressor Technology for Modular EOS/ESD Protection Circuit Designs

Protection circuits for very high frequency ultrasound systems

Spice Simulation and Experimental Study of Transmission Lines with TVSs Excited by EMP

Simulation of Simplified Cascade Waveguide Plasma Limiter under High Power Microwave

Transient Voltage Suppressor Based on Diode-Triggered Low-Voltage Silicon Controlled Rectifier

High power microwave effect of electrostatic discharge type GGMOS protection device

Development of the Plasma Limiter for High Power Microwave Weapon Protection

Selection of Protection Measure for Very Fast Transient Overvoltage of 500 Kv GIS

Simulation study of electromagnetic protection of ignition chip

Transient Response of Transient Voltage Suppressor Device under EMP with Fast Rise Time

Mixed Simulation of PCB Circuit Illuminated by High Power Microwave with Different Frequencies

Simulation Analysis of High Power Microwave Propagation Properties in a Simplified Plasma Limiter