Abstract:With the continuous innovation and improvement of electronic information and systems, the transmission power in the equipment is also increasing. For the propagation of high-power microwaves, not only the transmission characteristics of high-power microwaves should be considered, but also the protection measures should be taken to prevent the damage caused by excessive pulses on the back-end equipment. In this article, the characteristics of waveguide plasma limiter are studied based on the plasma formed by low pressure microwave gas discharge, which reflects and absorbs electromagnetic waves. At the same time, in response to the potential power leakage problem of single-stage plasma limiters in protecting high-power microwaves, a protective device is proposed for the combination of plasma limiters and PIN limiters in rectangular waveguides. When the incident microwave intensity is strong, the electronic components are protected from burning by plasma. When the front-end plasma limiter fails to exert its effect and causes power leakage, the transmitted microwave energy is attenuated by the subsequent PIN diode limiter circuit, causing its strength to fall below the safety threshold. This limiter system model can be controlled and described by the electromagnetic (EM) fields, plasma physics and PIN equivalent circuit model. In the multi-physics cascaded waveguide limiter system, the spectral-element time-domain (SETD) method is used for system integration and self-consistent simulation analysis. The results show that the limiting performance of the cascaded limiter is much better than that of the single-stage plasma limiter under the action of HPM pulses. This research provides theoretical guidance for the use of plasma limiting devices to protect against high-power microwave damage.

Development of the Plasma Limiter for High Power Microwave Weapon Protection

Simulation of Simplified Cascade Waveguide Plasma Limiter under High Power Microwave

Numerical simulation of waveguide plasma limiter under high power microwave based on the SETD method

Simulation Analysis of High Power Microwave Propagation Properties in a Simplified Plasma Limiter

Immunity Analysis and Experimental Investigation of a Low-Noise Amplifier Using a Transient Voltage Suppressor Diode under Direct Current Injection of HPM Pulses

An Electromagnetic-Plasma Fluid Model Simulation of Waveguide Plasma Limiter Filled with Different Easily Ionized Inert Gas

A High-Power Microwave Limiter Using A Self-Actuated Plasma-Based EIT Topology

Plasma-discharge-integrated slot structure for microwave power limiter

Analysis of the Research Development on HPM/EMP Protection

Research on high power microwave weapons

The Development and Applications of Directed Energy Vehicle Stopper System with High Power Microwave

Microwave Power Limiter Having H-Shaped Slot Structure With Enhanced Plasma Discharge by Electrostatic Potential

Small-Size Integrated Shielding Diaphragm in Miniaturized High-Power Microwave Cavity

High power microwave devices: Development since 1880

Design and Application of High-Density Cold Plasma Devices Based on High Curvature Spiked Tungsten Structured Electrodes

Development of Foreign High-Powered Microwave Weapons and Prospects of Future Applications in Space-Based Target Defense and Air Defense,

High power microwave technologies for vehicle integration

Transient Analysis of Absorption Characteristics of Argon Plasma Column Array under High-Power Microwave Irradiation

Application of High Power Microwave Weapons in Air Defense

Research on New Technology on Protection of Electronic Systems from High Power Electromagnetic Pulse

Analysis on Feasibility of High Power Microwave Weapons Attacking Satellite Payload