Abstract:A grid-forming (GFM) inverter can effectively support active power and reactive power, and the stability problem induced by the low inertia can be thereby alleviated in a power electronics-dominated power system. Yet, the voltage source characteristic presented by the grid-forming inverter induces an overcurrent problem during a short-circuit fault. Furthermore, the time delay induces an inrush current in traditional digital control, triggered by a predefined timing sequence. To address the overcurrent problem of the GFM inverter controlled by the digital controller, the operation characteristics of GFM inverters under grid-voltage drops are investigated, and a mathematical model of the instantaneous fault current is established, which depicts the relationship between the instantaneous fault current's magnitude, grid-voltage drop severity, equivalent output impedance, and current inner-loop response speed. Then, a Set–Reset (SR) latch-based dynamic current limitation with event-triggered control is proposed for the low-voltage ride-through of the GFM inverter. In the proposed method, the current limitation is enabled during grid fault, and the active and reactive powers can be recovered rapidly after fault clearance. Meanwhile, the active and reactive power references are designed to enhance synchronization stability during the grid fault. The proposed method addresses the issue of the repeated switching of virtual impedance during grid fault and achieves rapid power recovery after fault clearance. In addition, the proposed method uses the logic of event triggers to respond to the overcurrent event in real time and realize overcurrent protection. The simulation and experimental results demonstrate the effectiveness of the proposed method in current limitation and active-power recovery after fault clearance.

A General Current Limiting Strategy of Grid-Forming Converters Based on Adaptive Virtual Impedance Regulated by Fuzzy PI Control

An Adaptive Current-Limiting Strategy for Grid-Forming Converters under Grid Faults

An Adaptive Virtual-Impedance-Based Current-Limiting Method with the Functionality of Transient Stability Enhancement for Grid-Forming Converter

Dynamic Current-Limitation Strategy of Grid-Forming Inverters Based on SR Latches

An Improved Current-Limiting Control Strategy of Grid-Forming Inverter During Grid Fault

Transient Stability Enhancement of Current Limited-GFM Inverters Based on Varying Virtual Impedance

Reactive Power Characteristics and FRT Strategy for Grid-Forming Converters with Virtual Impedance-Based Current Limiting

A Novel Fault Ride Through Strategy for Grid-Connected Virtual Synchronous Generators: Power Angle Stability Enhancement and Current Limiting

Adaptive Supplementary Control of VSG Based on Virtual Impedance for Current Limiting in Grid-Connected and Islanded Microgrids

Cross-Forming Control and Fault Current Limiting for Grid-Forming Inverters

Optimal short‐circuit current control of the grid‐forming converter during grid fault condition

Analysis and Benchmarking of Grid-Forming Control for Power Converters

Dynamic Current Limiting of Grid-forming Converters for Transient Synchronization Stability Enhancement

Adaptive low voltage crossing strategy for symmetrical faults of networked inverters

Improved Dynamic Response in Grid-Forming Converters with Current Limiting Control during Fault Conditions

Control strategy for current limitation and maximum capacity utilization of grid connected PV inverter under unbalanced grid conditions

Current-Synchronization Control of Grid-Forming Converters for Fault Current Limiting and Enhanced Synchronization Stability

An overview of hybrid control strategy presenting grid-following and grid-forming capabilities

Grid Forming Converters in Renewable Energy Sources Dominated Power Grid: Control Strategy, Stability, Application, and Challenges

Current limiting strategies for grid forming inverters under low voltage ride through

Multiple Loops of Current-Limiting Control for Grid-forming Inverters in the Overload Conditions