Abstract:A grid-forming (GFM) inverter can effectively support active power and reactive power, and the stability problem induced by the low inertia can be thereby alleviated in a power electronics-dominated power system. Yet, the voltage source characteristic presented by the grid-forming inverter induces an overcurrent problem during a short-circuit fault. Furthermore, the time delay induces an inrush current in traditional digital control, triggered by a predefined timing sequence. To address the overcurrent problem of the GFM inverter controlled by the digital controller, the operation characteristics of GFM inverters under grid-voltage drops are investigated, and a mathematical model of the instantaneous fault current is established, which depicts the relationship between the instantaneous fault current's magnitude, grid-voltage drop severity, equivalent output impedance, and current inner-loop response speed. Then, a Set–Reset (SR) latch-based dynamic current limitation with event-triggered control is proposed for the low-voltage ride-through of the GFM inverter. In the proposed method, the current limitation is enabled during grid fault, and the active and reactive powers can be recovered rapidly after fault clearance. Meanwhile, the active and reactive power references are designed to enhance synchronization stability during the grid fault. The proposed method addresses the issue of the repeated switching of virtual impedance during grid fault and achieves rapid power recovery after fault clearance. In addition, the proposed method uses the logic of event triggers to respond to the overcurrent event in real time and realize overcurrent protection. The simulation and experimental results demonstrate the effectiveness of the proposed method in current limitation and active-power recovery after fault clearance.

Reactive Power Characteristics and FRT Strategy for Grid-Forming Converters with Virtual Impedance-Based Current Limiting

Fault Ride-Through Control of Grid-Connected Photovoltaic Power Plants: A Review

Zero-Voltage Ride-Through of Flexible Power Control Strategy in Single-Phase Grid-Connected Photovoltaic Inverters

Control Method for Fault Ride-through of DFIG-based Wind Turbines Applied to Weak Grids

A Novel Fault Ride Through Strategy for Grid-Connected Virtual Synchronous Generators: Power Angle Stability Enhancement and Current Limiting

A Low-Voltage Ride-Through Control Strategy for Three-Phase Grid-Connected Pv Systems

Active Power and Voltage Cooperative Control for Improving Fault Ride-Through Capability of Grid-Forming Converters

An Adaptive Virtual-Impedance-Based Current-Limiting Method with the Functionality of Transient Stability Enhancement for Grid-Forming Converter

An Adaptive Current-Limiting Strategy for Grid-Forming Converters under Grid Faults

A General Current Limiting Strategy of Grid-Forming Converters Based on Adaptive Virtual Impedance Regulated by Fuzzy PI Control

Analysis and Benchmarking of Grid-Forming Control for Power Converters

Control of Virtual Synchronous Generator with Improved Transient Angle Stability Under Symmetric and Asymmetric Short Circuit Fault

Grid Forming Converters in Renewable Energy Sources Dominated Power Grid: Control Strategy, Stability, Application, and Challenges

Dynamic Current-Limitation Strategy of Grid-Forming Inverters Based on SR Latches

Transient Stability Enhancement of Current Limited-GFM Inverters Based on Varying Virtual Impedance

A Comprehensive Lvrt Control Strategy for Dfig Wind Turbines with Enhanced Reactive Power Support

A Fault Ride-through Method of VSG Based on Reactive Power Feedback Coefficient Optimization

Improved Dynamic Response in Grid-Forming Converters with Current Limiting Control during Fault Conditions

Grid-Forming Control Based On Emulated Synchronous Condenser Strategy Compliant With Challenging Grid Code Requirements

An Improved Current-Limiting Control Strategy of Grid-Forming Inverter During Grid Fault

Fault Current Limitation Based Photovoltaic DC Distribution System Fault Ride Through Control