Abstract:Abstract In this paper, we propose a thermal wind speed sensor Verilog-A model with thermal-fluid-electric hybrid characteristics. Because the structure of the thermal wind sensor and the interface circuit chip are designed separately, which cannot effectively carry out MEMS-IC (integrated circuit) co-simulation, the overall performance of the sensor and interface circuit chip is prone to large deviation. At the same time, the separation of MEMS structure and IC design process leads to long product development cycle and high cost. This paper proposes an improved simulation model by analyzing the behavior characteristics of the thermal wind speed sensor. The simulation model consists of 11 thermistors, 3 capacitors, a voltage-controlled voltage source, and a voltage-controlled current source. The Taylor series expansion of the differential equation of heat conduction is carried out, and then the thermistor and capacitor networks are established according to the corresponding relationship between the thermal parameters and the electrical parameters, including the thermal conduction unit, the convection unit and the heat capacity in the chip. The model fully considers the effects of various physical effects and parasitic effects, and is implemented using the hardware description language Verilog-A. The sensor and interface circuit can be simulated simultaneously to optimize the circuit design. It is beneficial to the integration of sensors and interface circuit, reducing the number of tape-outs, increasing the success rate, and reducing costs. The consistency between the simulation results and the experimental curves verified the correctness of the macro model. The behavior characteristics of constant power (CP) and constant temperature heating were described. In CP mode, the output voltage error is less than ± 6.5%, the chip temperature error is less than 4.0%. The presented modeling approach can be the basis for the development of complete MEMS-IC design technology library of thermal wind speed sensor, aiming at optimum designs of integrated thermal wind speed sensor.

Efficient and Accurate System-level Simulation Compatible Macromodel for MEMS Diode-base Micro-Pirani Vacuum Sensor

Macro modeling method for electrostatic-drive silicon diaphragm

Research Status of Macro-Modeling of MEMS Devices for Systems Level Simulations

Modeling and Simulation of Electrostatic Micropump Based on MEMS

A New Modeling Method of MEMS System's Noise

An efficient macro model for CMOS-MEMS thermal wind speed sensor

A Novel Hybrid Macromodel for MEMS System-Level Modeling and Simulation

Efficient system-level simulations of thermal wind sensors considering environmental factors

A Novel Parametric System-Level Modeling Method for MEMS Devices Combining Artificial Neural Networks and Behavior Description

An Efficient Macromodel Extraction Strategy for Packaged MEMS Thermal Wind Sensor Considering Multiphysics

System-Level Optimization of MEMS Thermal Wind Sensor Based on the Co-Simulation of Macromodel and Board-Level Interface Circuits

System-level Modeling and Simulation for an Electrostatic-Feedback Microaccelerometer Based on Equivalent Electrical Representation

An Improved Physical Model Considering Mirco-Nano Scale Effects for Numerical Simulation of Pirani Vacuum Gauges

Design and Optimization of Interface Circuits of MEMS Thermal Wind Speed Sensor Based on a Macro Model

Hybrid Macromodels for Modeling and Simulation of a Z-Axis Micro Accelerometer

Direct Simulation Analysis of Electromechanical Coupling and Joule Heating Effect of a MEMS SiC Piezoresistive Accelerometer

A Hybrid System-Level Modeling and Simulation Methodology for Structurally Complex Microelectromechanical Systems

System Level Modeling and Simulation of a Micro Resonant Pressure Sensor

Review of Research on Macromodel for MEMS System-level Simulation

Macromodeling of Electrostatic Gap and its Application to MEMS Design

Modeling of Capacitive Microaccelerometers with Squeeze Film Damping and Electrostatic Effects Using Model Order Reduction