Abstract:Numerical models of electrochemical sensors using screen-printed electrodes (SPEs) are limited. Simulating the dynamic response of SPEs is challenging due to their complex geometry and kinetic behavior. In this paper, we present a general process by which SPEs can be modeled using commercial finite element software, COMSOL Multiphysics. Parameters such as electroactive surface area and the heterogenous rate constant were derived empirically using a commonly used redox couple of hexaammineruthenium (III), , and hexaammineruthenium (II), . Experimentally derived parameters were used in the model and a transient numerical simulation was run to replicate the cyclic voltagramms procured from experiment. The results show that the electroactive area was measured to be 2.3 (± 0.674), which was less than the 3.14 geometric area. In addition, the heterogeneous kinetic constant at various voltage scanning rates, ranging from 25 to 500 mV/s, were measured. Uncompensated resistance was measured as 301.9 (± 1.6) and was also incorporated as a parameters in the model. Numerical results as represented by voltagramms shapes were consistent with experimental results. The model was able to predict the maximum anodic current density with an accuracy of 30.5%, 22.9%, 13.4%, 16.2%, 12.8%, 14.8%, and 14.6% for scan rates ranging from 25 to 500 mV/s (25, 50, 75, 100, 200, 300, 400, and 500 mV/s, respectively). The model was more accurate in predicting maximum cathodic currents with accuracy values of 1.7%, 1.2%, 5.5%, 4.1%, 1.7%, 2.4%, and 2.2% for scan rates ranging from 25 to 500 mV/s. The results demonstrate the first attempt to model the SPEs which incorporate experimentally derived parameters. These types of models are expected to help biosensor researchers simulate sensor response before fabrication and testing.

Low-Cost Computational Models for Biomedical Sensors

Application of Molecular Simulation in Biosensor Development

Physical Sensors And Measurement

Chemical Sensors and Measurement

Passive and Wireless Near Field Communication Tag Sensors for Biochemical Sensing with Smartphone

A Surface Plasmon Resonance (SPR)-Based Biosensor Simulation Platform for Performance Evaluation of Different Constructional Configurations

Computational Biomaterials: Computational Simulations for Biomedicine

Simulation of Chemical Engineering Memristive Biosensor

Optimizing biomagnetic sensor performance through in silico diagnostics: A novel approach with BEST (Biomagnetism Evaluation via Simulated Testing)

Review of Physical Models for Numerical Simulation of Semiconductor Microsensors

Dynamic Single-Molecule Sensors: A Theoretical Study

Low-cost and convenient screening of disease using analysis of physical measurements and recordings

Sensitivity Analysis of Biosensors Based on a Dielectric-Modulated L-Shaped Gate Field-Effect Transistor

Efficient and Accurate System-level Simulation Compatible Macromodel for MEMS Diode-base Micro-Pirani Vacuum Sensor

Battery-free, tuning circuit–inspired wireless sensor systems for detection of multiple biomarkers in bodily fluids

Computer simulation of microsensors and microactuators

Mechanism of Bio-Inspired Ultrasensitive Low Frequency Sensor with Mechanics Analysis

Biosensor Design Through Molecular Dynamics Simulation

An Improved Detection Limit and Working Range of Lateral Flow Assays Based on a Mathematical Model

Research and Design of High Sensitivity FBAR Micro-mass Sensors

Kinetic and geometric considerations in modeling screen-printed electrode-based sensors