Corrosion, Permeation and Mass Transfer Mechanisms of Alkali Metals in Corundum Refractories

Ying Zhao,Youcheng Cai,Xue Luan,Guishi Cheng,Xiaoqiang Wang,Changqing Dong

DOI: https://doi.org/10.1016/j.ceramint.2024.06.159

IF: 5.532

2024-01-01

Ceramics International

Abstract:During the operation of the waste liquid incinerator, the alkali metal slag might adhere to the surface of the refractory material to form an inhomogeneous solid slag layer, causing the furnace lining to be simultaneously corroded by three phases of alkali metals: vapor, molten salt, and slag. This phenomenon intensifies the damage to the refractory material. Therefore, this paper investigates the mass transfer and permeation process, phase change process and corrosion rate of Na2CO3 inside corundum refractory materials in three phases: Na vapor, molten Na2CO3 and Na-slag. The results showed that alkali vapor penetrated the interior through the pores, and the NaAlO2 and β-Al2O3 generated by the reaction led to the volume expansion and microcracks. Na vapor continued to penetrate the interior along the cracks and eroded the sample, and the higher the temperature the greater Na vapor penetration. In vapor phase corrosion, the effect of corrosion time on the erosion resistance of corundum refractories is less than that of temperature, and the increase in corrosion time does not lead to the formation of additional new phases. In the molten salt corrosion experiments, it was found that the molten salt corrosion was accompanied by vapor phase corrosion at 1100 °C, and the amount of Na2CO3 has a greater effect on the corroded mass than the temperature. Comparing the corrosion of refractory materials by the three phases of Na2CO3, the molten salt corrosion rate was the highest, followed by the vapor phase corrosion, and finally the slag corrosion. It is concluded that the slag layer can effectively prevent the corrosion of the refractory material by alkali metal molten salts and vapors, thus prolonging the service life of refractories.