Abstract:Cubic silicon carbide (3C‐SiC) crystals are grown by the close space physical vapor transport (CS‐PVT) method while the growth temperature, pressure, and the nitrogen doping are varied during three different growth run series. The influence of the growth parameters on the step‐controlled surface morphology and stacking fault density is systematically investigated and discussed. A systematic approach to determine the most crucial growth parameters and their effect on the surface morphology and defect density of sublimation grown (001) cubic silicon carbide (3C‐SiC) is conducted. Close space physical vapor transport (CS‐PVT) growth on 3C‐SiC and 4° off oriented homoepitaxial chemical vapor deposition (CVD) grown seeding layers is performed. For each growth run, one growth parameter, e.g., temperature, pressure, or N2 flux is varied, while the other parameters are kept constant. Raman spectroscopy, potassium hydroxide (KOH) etching, as well as optical microscopy and atomic force microscopy (AFM) are used for the sample characterization. Step‐flow‐controlled growth is observed on all grown samples, while the stacking fault density is generally reduced with respect to the seeding layers. Increased temperature as well as increased pressure leads to roughening of the growth surface attributed to step bunching, while their effect on the stacking fault density seems to be only minor in the analyzed parameter range. Areas of strongly enhanced step bunching are present on all samples, and this effect is more pronounced at higher temperature and pressure. Increased nitrogen doping leads to a decreased stacking fault density but also increases the length of remaining stacking faults. The surface morphology is influenced by N2 on a macroscopic level rather than on microscopic scale.

Surface Control of AlN Single Crystal Growth on SiC Substrate

Growth of High Quality AlN on Sapphire with Multi-Growth Approaches

Improvement of surface morphology by optimizing the growth conditions in solution growth of SiC single crystal

Sublimation Growth of Aluminum Nitride on Silicon Carbide Substrate with Aluminum Nitride–silicon Carbide Alloy Transition Layer

High-Quality AlN Grown by a Combination of Substrate Pretreatment and Periodic Growth Mode Control

Control of Aln Single Crystal Nucleation: an Insight into the Crystal Growth Habit in the Initial Stages of the Physical Vapor Transport Method

Evolution of 2-inch AlN Single Crystal Grown on SiC Seed via PVT method

Epitaxial AlN film with improved quality on Si (111) substrates realized by boron pretreatment via MOCVD

Optimization of the process parameters for the AlN crystal growth in the PVT method through an improved numerical simulation considering partial pressure of gas phases

Improving the structural performance of low-temperature sputtered AlN on silicon substrate

Oxygen reduction through specific surface area control of AlN powder for AlN single-crystal growth by physical vapor transport

Optimizing crucible geometry to improve the quality of AlN crystals by the physical vapor transport method

Surface Morphology of AlN Nucleation Layer Grown on Si by MOCVD

The Effect of Aluminum Nitride-Silicon Carbide Alloy Buffer Layers on the Sublimation Growth of Aluminum Nitride on Sic (0001) Substrates

Seeded Growth of AlN Crystals on Nonpolar Seeds Via Physical Vapor Transport

Atomic Simulation of Homoepitaxial AlN on Non-Polar (11-20) Plane

Surface Preparation and Homoepitaxial Deposition of AlN on (0001)-Oriented AlN Substrates by Metalorganic Chemical Vapor Deposition

Controlled Growth of One-dimensional 3C–SiC nanostructures with stable morphology

Growth of high quality and uniformity AlGaN/GaN heterostructures on Si substrates using a single AlGaN layer with low Al composition

Effect of initial condition on the quality of GaN film and AlGaN/GaN heterojunction grown on flat sapphire substrate with ex-situ sputtered AlN by MOCVD

Effect of Growth Conditions on the Surface Morphology and Defect Density of CS‐PVT‐Grown 3C‐SiC