Abstract:Drawing-tower fiber Bragg grating (FBG) array can be used in health monitoring of bridges, pipelines and some large-scale projects to realize temperature, stress and vibration quasi-distributed sensing. The grating array sensing system can detect the changes of the tested physical parameters by measuring the central wavelength of the grating. However, for the sensing system based on identical grating array consisting of uniform FBGs, it cannot measure accurately the shift of the reflective wavelength of a grating in the array due to the sidelobe superposition of the gratings. Compared with uniform Bragg grating, apodized FBG has smaller reflection peak sidelobes. It means that the reflection power of the apodized FBG can be concentrated to the central wavelength region, and the reflection peak signal will be not interfered with those of other gratings. In this paper, an apodized FBG array was in-line fabricated in a single mode fiber by on a drawing tower and used for dense quasi-distributed temperature sensing. The obtained apodized FBGs have a full width at half maximum (FWHM) of 0.09 nm and their sidelobes were decreased by -21.9 dB. A 1000-meter-long array consisting of 10000 apodized gratings was successfully fabricated and used for quasi-distributed temperature sensing. These gratings have good consistency, low transmission loss and good mechanical properties. Experimental results show that the array can accurately measure quasi-distributed temperature fields and the temperature sensitivity is 10.15 pm/degrees C. It is expected that the apodized grating array can find more applications in many fields.

Adaptive Simulated Annealing Algorithm for the Fiber Bragg Grating Distributed Strain Sensing

Simulation and Reconstruction for Nonuniform Strain Profile of Fiber Bragg Grating Sensor

Structural Instability-Enabled Mechanical Sensors Using Fiber Bragg Grating

Improving the Performance of FBG Sensors in a WDM Network Using a Simulated Annealing Technique

Research On Measurement Of Fiber Bragg Grating Considering The Cross-Sensitivity Of Temperature And Strain

Non-minimum Phase Reconstruction from Amplitude Data in Fiber Bragg Gratings Using an Adaptive Simulated Annealing Algorithm

Non-uniform strain field reconstruction of FBG using an adaptive Nelder–Mead algorithm

Embedded fibre Bragg grating sensors for non-uniform strain sensing in composite structures

Simulation of Fiber Bragg Grating Using Different Physical Parameters for Investigating the Effectiveness on Strain Sensor Measurements

Simultaneous Independent Temperature and Strain Measurement Using One Fiber Bragg Grating Based on the Etching Technique

Analysis and Simulation on Stress and Strain of Fiber Bragg Grating in Smart Metal Structure

Distributed strain interrogation with a linearly chirped fiber Bragg grating based on an optoelectronic oscillator

Temperature-controlled Fiber Bragg Grating Dynamic Strain Detection System

Additive Non-Uniform Random Sampling in Superimposed Fiber Bragg Grating Strain Gauge

A Method of Strain Measurement Based on Fiber Bragg Grating Sensors

Quasi-Distributed Temperature and Strain Sensors Based on Series-Integrated Fiber Bragg Gratings

Quasi-Distributed Temperature Sensing Using Apodized Fiber Bragg Grating Array

A New FBG Based Dynamic-Strain Interrogation System

Design and application of a fiber Bragg grating strain sensor with enhanced sensitivity in the small-scale dam model

Semicomputational calculation of Bragg shift in stratified materials

The Measurement and Discrimination of Asymmetric Non-Uniform Strain Distribution Based on Spectrum Characterization of Fbg Sensor