Abstract:Fiber Bragg grating optical sensors are nowadays widely employed for strain measurement for structural health monitoring and in experimental mechanics. Compared to other techniques, i.e. electrical strain gauges, fiber Bragg grating offer immunity to electromagnetic interference and allow for long transmission lead lines. Moreover, thanks to multiplexing interrogation, several sensors can be photo-imprinted into a single fiber core allowing for strain evaluation at multiple locations simultaneously. They have high adaptability to composite materials, particularly because it is possible to be embedded into laminates without affecting their strength and stiffness. Fiber Bragg grating strain measurements are based on the detection of the wavelength shift of their peak reflected spectrum. However, subjected to strain gradients, the spectral response of fiber Bragg grating sensors may be distorted and the sharp peak may not be retained. In this work, the response of fiber Bragg grating sensors having different grating lengths and bonded to the surface of a carbon fiber-reinforced twill woven laminate was analyzed. The analysis combined transfer matrix (T-matrix) with digital image correlation methods. Digital image correlation technique was used to capture the non-uniform strain fields in the woven composites and measured strains were employed in T-Matrix algorithm to simulate fiber Bragg grating response. Using this approach, the effect of the length of the fiber Bragg grating on the strain measurement is assessed and results discussed. Moreover, it is shown that T-matrix formulation combined with a non-contact strain field measurement technique, as DIC, is an appropriate technique to simulate the behavior of fiber Bragg grating bonded to composite materials of complex microstructure.

Simulation of Fiber Bragg Grating Using Different Physical Parameters for Investigating the Effectiveness on Strain Sensor Measurements

Simulation and Reconstruction for Nonuniform Strain Profile of Fiber Bragg Grating Sensor

Strain Sensor Based on Gourd-Shaped Single-Mode-multimode-single-mode Hybrid Optical Fibre Structure.

Research On Measurement Of Fiber Bragg Grating Considering The Cross-Sensitivity Of Temperature And Strain

Simulation of a Fiber-Optic Bragg Sensor with a Tilted Grid

Embedded fibre Bragg grating sensors for non-uniform strain sensing in composite structures

Mathematical Modeling of π-Phase-Shifted Fiber Bragg Grating and its Application for Strain Measurement in Epoxy Resin Cantilever Beam

Fiber Bragg Gratings Sensor Strain–Optic Behavior with Different Polymeric Coatings Subjected to Transverse Strain

Simulation and Measurement of Strain Waveform under Vibration Using Fiber Bragg Gratings

Fiber Bragg grating sensors for monitoring of physical parameters: a comprehensive review

Design and Simulation of Fiber Bragg Grating by Comsol Multiphysics Software Shaymaa Riyadh

Experimental analysis of the response of fiber Bragg grating sensors under non-uniform strain field in a twill woven composite

Research on basic principle and calibration experiment of fiber bragg grating sensor

Influence of fiber Bragg grating spectrum degradation on the performance of sensor interrogation algorithms

Adaptive Simulated Annealing Algorithm for the Fiber Bragg Grating Distributed Strain Sensing

Numerical Investigation of Stress-Strain State Effects on Strain Measurements with Fiber Bragg Grating Sensors

"DISCRIMINATION OF TEMPERATURE AND STRAIN INTERFERENCE IN FBG SENSORS USING TAPERED OPTICAL FIBER SENSOR "

Analysis of Induced-Birefringence Effects on Fiber Bragg Gratings

Experimental comparison of Fiber Bragg Grating installation techniques for aerospace systems

Compact high-resolution FBG strain interrogator based on laser-written 3D scattering structure in flat optical fiber