Abstract:Fiber Bragg grating optical sensors are nowadays widely employed for strain measurement for structural health monitoring and in experimental mechanics. Compared to other techniques, i.e. electrical strain gauges, fiber Bragg grating offer immunity to electromagnetic interference and allow for long transmission lead lines. Moreover, thanks to multiplexing interrogation, several sensors can be photo-imprinted into a single fiber core allowing for strain evaluation at multiple locations simultaneously. They have high adaptability to composite materials, particularly because it is possible to be embedded into laminates without affecting their strength and stiffness. Fiber Bragg grating strain measurements are based on the detection of the wavelength shift of their peak reflected spectrum. However, subjected to strain gradients, the spectral response of fiber Bragg grating sensors may be distorted and the sharp peak may not be retained. In this work, the response of fiber Bragg grating sensors having different grating lengths and bonded to the surface of a carbon fiber-reinforced twill woven laminate was analyzed. The analysis combined transfer matrix (T-matrix) with digital image correlation methods. Digital image correlation technique was used to capture the non-uniform strain fields in the woven composites and measured strains were employed in T-Matrix algorithm to simulate fiber Bragg grating response. Using this approach, the effect of the length of the fiber Bragg grating on the strain measurement is assessed and results discussed. Moreover, it is shown that T-matrix formulation combined with a non-contact strain field measurement technique, as DIC, is an appropriate technique to simulate the behavior of fiber Bragg grating bonded to composite materials of complex microstructure.

Numerical Investigation of Stress-Strain State Effects on Strain Measurements with Fiber Bragg Grating Sensors

Simulation and Reconstruction for Nonuniform Strain Profile of Fiber Bragg Grating Sensor

Fiber Bragg Gratings Sensor Strain–Optic Behavior with Different Polymeric Coatings Subjected to Transverse Strain

Research On Measurement Of Fiber Bragg Grating Considering The Cross-Sensitivity Of Temperature And Strain

Analysis of Induced-Birefringence Effects on Fiber Bragg Gratings

Measurement of strains by optical fiber Bragg grating sensors embedded into polymer composite material

Use of the Stokes Parameters of Fbg for Transverse Strain Sensing and the Optimization of the Grating Structure

Simulation of Fiber Bragg Grating Using Different Physical Parameters for Investigating the Effectiveness on Strain Sensor Measurements

Semicomputational calculation of Bragg shift in stratified materials

Fiber Cross-Section Shape Effect on Rate-Dependent Behavior of Polymer Matrix Composites with Fiber Bragg Grating Sensors

Thermal and Stress Strain Analysis of the Implanted Fiber Bragg Grating in a Composite Insulator Rod

Experimental analysis of the response of fiber Bragg grating sensors under non-uniform strain field in a twill woven composite

Strain measurement in flexibility material using fiber Bragg gratings

Strain Sensing of Modern Composite Materials with A Spatial Wavelength-Division Multiplexed Fiber Grating Network

Simulation and Measurement of Strain Waveform under Vibration Using Fiber Bragg Gratings

A Method of Strain Measurement Based on Fiber Bragg Grating Sensors

3-Dimensional Strain Sensor in Fiber Bragg Grating

Mathematical Modeling of π-Phase-Shifted Fiber Bragg Grating and its Application for Strain Measurement in Epoxy Resin Cantilever Beam

Realization of Nano Static Strain Sensing with Fiber Bragg Gratings Interrogated by Narrow Linewidth Tunable Lasers

Embedded fibre Bragg grating sensors for non-uniform strain sensing in composite structures

Strain Measurement and Defect Detection with Fiber-Optic Sensors Embedded into the Cement Sample