Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

FLOW NON-UNIFORMITY AND HEAT TRANSFER IN ANNULAR PLATE-FIN RADIATOR

Flow and Heat Transfer Analysis of Perforated Fin in Compact Heat Exchanger

Natural convection heat transfer in concentric annuli with nanofluids

Fluid Flow and Heat Transfer Performance in a Micro-Reactor with Non-Uniform Micro-Pin-fin Arrays for Hydrogen Production at Low Reynolds Number

Cooling Performance Analysis of Outside Fins of the Closed Circuit Axial Piston Transmission

Numerical Simulation Study on Thermal-Hydraulic Performances of Vehicular Radiator Heat Transfer Units

Experimental Investigation on Flow and Heat Transfer Performance of a Novel Heat Fin-Plate Radiator for Electronic Cooling

Numerical Simulation of Heat Transfer in Finned Tube of Heat Recovery Unit Using Fluid-Solid Coupled Method

Effects of Fin Parameters on the Thermal Hydraulic Performance of a Vehicular Radiator

One-dimension and three-dimension collaborative simulation study of the influence of non-uniform inlet airflow on the heat transfer performance of automobile radiators

Heat Transfer Analysis of Different Coolant in the Waist Tubes of a Radiator and Performance Prediction Based on Artificial Neural Network

Numerical Analysis of Header Structure Improvement in a Plate-Fin Heat Exchanger

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Performance analysis and optimization of heat pipe-based radiator for space nuclear power system

FLUID FLOW AND CONVECTIVE HEAT TRANSFER IN A VERTICAL POROUS ANNULUS

Numerical investigation on Enhancing Heating performance in Automotive Radiator

Experimental Study of Composite Heat Pipe Radiator in Thermal Management of Electronic Components

Numerical simulation of slit fin cell's flow and heat transfer

Performance Analysis and Structural Optimization of a Finned Liquid-Cooling Radiator for Chip Heat Dissipation

Flow and heat transfer performances of tubes with internal longitudinal plat-rectangle fins

Complex Turbulent Flow and Heat Transfer Characteristics of Tubes with Internal Longitudinal Plate-Rectangle Fins in EGR Cooler