Numerical simulation and experimental study on geometry variations and process control method of vertical hot ring rolling
Xiaokai Wang,Lin Hua,Xinghui Han,Xiaoxuan Wang,Dehui Wang,Yali Liu
DOI: https://doi.org/10.1007/s00170-014-5770-2
IF: 3.563
2014-04-20
The International Journal of Advanced Manufacturing Technology
Abstract:The accurate geometry and effective control during the ring rolling process are the prerequisites for the ring products’ precise forming. In this paper, the interaction modes and rules between ring and rolls in vertical hot ring rolling (VHRR) process are analyzed, and the change laws of the ring’s geometry are studied. Based on the ABAQUS/Explicit software and its subroutine VUAMP, the finite element (FE) model of the VHRR process with measurement and control is established. Then, the ring rolling process of a groove-section profile ring is simulated. During the simulation, the ring’s outer diameter, roundness error, and the stability of the rolling process are detected in time, and the close-loop control of feed plan of the drive roll and measuring roll are also employed. The results obtained show the following: (1) Four feed stages are divided by means of a step-down feed movement, that is, bite stage, main rolling stage, precise forming stage, and sizing stage. (2) At bite and main rolling stages of the VHRR process, the ring’s center swings in a spiral line, and the rolling process is unstable, the ring’s roundness becomes worse, while the process is entering the precise forming stage, by means of the guide roll, the rolling process becomes steady and the ring’s roundness tends to be better. (3) The measuring roll contacts with the ring at the main rolling stage, afterwards, it is pushed back at the precise forming stage by ring’s growth. When the measuring roll meets the desired displacement value, a stop feeding command will be fed back, and the ring rolling process enters the sizing stage. At the sizing stage, the ring’s outer diameter still increases a little. (4) A series of VHRR experiments are conducted, and FE results are in good agreement with experimental results. The absolute errors of the ring’s outer diameter and the roundness are within 1 mm. The research results of this paper have practical significance to guide the VHRR production.
engineering, manufacturing,automation & control systems