Abstract:The measurement of 226 Ra and the identification of 226 Ra-bearing minerals are important for studying the behavior of radium in the environment. Various instruments for measuring 226 Ra are currently used: among the radiometric techniques that measure in bulk (no spatialization), there are gamma spectrometers and alpha spectrometers. Other instruments such as SEM-EDS can map the chemical elements thus providing information on the distribution of 226 Ra, but are limited for ultra-trace analyses on natural geomaterials. Finally, autoradiography techniques can locate radioactivity, but are limited to the identification of the contribution of 226 Ra when the 238 U series is complete. This study focuses on spectroscopic autoradiography, a method for measuring both the energy of the alpha particle emissions and their positions on the autoradiograph. A gas detector based on a parallel ionization multiplier technology was used for this purpose. Alpha particle energy is dependent on the emitting radionuclides. In order to track the 226 Ra, the energy spectrum of the 238 U series was studied with modeling software. It appears possible to apply a thresholding on the energy spectrum to discriminate the 226 Ra from the first alpha emitters of the 238 U decay chain (i.e. 238 U, 234 U and 230 Th, all below 5 MeV). The developed method was applied to a U-mill tailing sample prepared as a thin section. The sample was heterogeneous in terms of radioactivity and was not at secular equilibrium with 238 U, as expected. The 226 Ra was identified and localized, and different regions of interest were also analyzed with SEM-EDS elements cartography. This revealed 226 Ra-rich barite (BaSO4) phases measured at 3 ppm Ra on average and containing no uranium; and uranium in siderite (FeCO 3 ), showing a strong 226 Ra deficit compared with secular equilibrium. Spectroscopic autoradiography opens up possibilities for the analysis of heterogeneous geological samples containing natural alpha emitters such as 238 U and 226 Ra: the 226 Ra can be localized and quantified at ultra-trace content, and the method developed can also identify newly (young) uranium phases by measuring 238 U/ 226 Ra activity disequilibrium.

THE APPLICATION OF LaBr_3(Ce) GAMMA RADIATION SCINTILLATION SPECTROMETER TO DIRECT DETERMINATION OF URANIUM CONTENT OF URANIUM ORE BODIES

Progress in AMS Measurement of U Isotope Ratios in Nanogram U Samples

Response of LaBr3:Ce Scintillation Detector Itself to Fast Neutrons

A Prototype of LaBr3:Ce in situ Gamma-Ray Spectrometer for Marine Environmental Monitoring

Isolation and Identification of a High-Efficiency Hexavalent Uranium Adsorption Strain and Preliminary Study of the Influencing Factors and Adsorption Mechanism

Optimization of an underwater in-situ LaBr3:Ce spectrometer with energy self-calibration and efficiency calibration

In Situ Assessment of Rare Earth Ore Grades and Veins in Rare Earth Mining via Portable X‐Ray Fluorescence and Gamma‐Ray Spectrometry

Raw signal improvement using beam shaping plasma modulation for uranium detection in ore using laser-induced breakdown spectroscopy

Energy Self-calibration and Low-Energy Efficiency Calibration for an Underwater In-Situ LaBr3:Ce Spectrometer

FAST TIMING: LIFETIME MEASUREMENTS WITH LaBr3(Ce) SCINTILLATORS

Using spectroscopic autoradiography of alpha particles for the quantitative mapping of 226 Ra ultra-traces in geo-materials

Highly Sensitive and Selective Uranium Detection in Natural Water Systems Using a Luminescent Mesoporous Metal-Organic Framework Equipped with Abundant Lewis Basic Sites: A Combined Batch, X-ray Absorption Spectroscopy, and First Principles Simulation Investigation.

Trace impurity analysis in uranium materials by rapid separation and ICP-MS/MS measurement with matrix matched external calibration

A Study on Neutron Energy Spectrum Estimation by LaBr3:Ce Detector

Study on the scintillation performance of CLLB:Ce scintillator and optimization of measurement method

[Influence of the Experiment Energy Dispersive X-Ray Fluorescence Measurement of Uranium by Different Excitation Source]

Monte Carlo simulation of gamma-ray spectra using a LaBr3 detector

Sensitive fluorescent determination of uranyl ions using a terbium (III) 4-sulfocalix[4]arene probe

Absolute Measurement of Uranium Concentration in Solution by Combining Liquid Scintillation Counting and Α Spectrometry

A simple method for Ce–Nd separation using nano-NaBiO3: Application in the isotopic analysis of U, Sr, Pb, Nd, and Hf in uranium ores

Quantitative Analysis and Efficiency Study of PSD Methods for a LaBr3:Ce Detector