Abstract:LaBr3:Ce crystals have good scintillation properties for X-ray spectroscopy. Initially, they were introduced for radiation imaging in medical physics with either a photomultiplier or SiPM readout, and they found extensive applications in homeland security and gamma-ray astronomy. We used 1 inch round LaBr3:Ce crystals to realize compact detectors with the SiPM array readout. The aim was a good energy resolution and a fast time response to detect low-energy X-rays around 100 keV. A natural application was found inside the FAMU experiment, at RIKEN RAL. Its aim is a precise measurement of the proton Zemach radius with impinging muons, to contribute to the solution to the so-called proton radius puzzle. Signals to be detected are characteristic X-rays around 130 KeV. A limit for this type of detector, as compared to the ones with a photomultiplier readout, is its poorer timing characteristics due to the large capacity of the SiPM arrays used. In particular, long signal falltimes are a problem in experiments such as FAMU, where a prompt background component must be separated from a delayed one (after 600 ns) in the signal X-rays to be detected. Dedicated studies were pursued to improve the timing characteristics of the used detectors, starting from hybrid ganging of SiPM cells; then developing a suitable zero pole circuit with a parallel ganging, where an increased overvoltage for the SiPM array was used to compensate for the signal decrease; and finally designing ad hoc electronics to split the 1 inch detector SiPM array into four quadrants, thus reducing the involved capacitances. The aim was to improve the detectors timing characteristics, especially falltime, while keeping a good FWHM energy resolution for low-energy X-ray detection.

FAST TIMING: LIFETIME MEASUREMENTS WITH LaBr3(Ce) SCINTILLATORS

Positron Annihilation Life Spectrometer with LaCl 3 :Ce 3+ Scintillator Crystal

Study on the scintillation performance of CLLB:Ce scintillator and optimization of measurement method

Advancements in High Density and Fast Scintillation Detector Materials

Improving the Time Resolution of Large-Area LaBr3:Ce Detectors with SiPM Array Readout

High-rate Gamma Spectrometry Using a LaBr3(Ce) Scintillator with a Fast Pulse Shaping

Ionization-density-dependent Scintillation Pulse Shape and Mechanism of Luminescence Quenching in LaBr 3 :Ce

Localisation of gamma-ray interaction points in thick monolithic CeBr3 and LaBr3:Ce scintillators

The Intrinsic Energy Resolution of LaBr$_3$(Ce) Crystal for GECAM

Study on the Time Response of a Barium Fluoride Scintillation Detector for Fast Pulse Radiation Detection

Response of LaBr3:Ce Scintillation Detector Itself to Fast Neutrons

Characterization of Large Volume 3.5 x 8 inches LaBr3:Ce Detectors

Exploring Scintillators and Cherenkov Radiators for MIP Timing Detectors

Cathodoluminescence spectral and lifetime mapping of Cs 4 PbBr 6 : fast lifetime and its scintillator application

A Large Area LaBr3/NaI Phoswich for Hard X-ray Astronomy

Experimental study on gamma ray induced light output deterioration in LaBr3:Ce scintillator

Utilization of synchrotron radiation for the measurement of fast fluorescence lifetimes of ions in solids

Record high time resolution of positron annihilation lifetime spectrometer achieved by double-stop setup and geometry optimization of scintillators

Scintillation properties of Eu-doped LiBr crystalline scintillators under X-, γ-ray, and neutron irradiation

The Energy Response of LaBr3(Ce), LaBr3(Ce,Sr) and NaI(Tl) Crystals for GECAM

A Prototype of LaBr3:Ce in situ Gamma-Ray Spectrometer for Marine Environmental Monitoring