Abstract:Long nanosecond pulses have been proven to be efficient at enhancing underwater LIBS emission. However, the quantitative analytical capability of underwater long-pulse LIBS has yet to be further revealed. In this work, we investigated the spectral characteristics by irradiating with a laser pulse of 120 ns duration. The alkali and alkaline earth metals Li, K and Ca and the transition element Mn were selected for analysis. It is shown that obvious self-reversal structures were observed in the spectra at high concentrations, making the calibration curves saturated. Correction was performed using the approximate Voigt function fitting method, which significantly improves the linearity of the calibration curves. In addition to the target metal elements, atomic lines of the matrix elements H and O in water were also observed, which can serve as promising internal standards for quantitative analysis. A comparison of the quantification performance with and without the internal standards demonstrates that the use of the internal standards is conducive to improving the robustness of the calibration approaches with higher determination coefficients. More importantly, the underwater LIBS signal stability is improved by more than 3 times, and the prediction error for validation samples is reduced by 2-4 times. The present results suggest that long ns pulses are favorable to significantly improving the qualitative and quantitative performance of underwater single-pulse LIBS, enabling long-pulse LIBS to have great potential to be applied to underwater in situ chemical analysis.

Energy Self-calibration and Low-Energy Efficiency Calibration for an Underwater In-Situ LaBr3:Ce Spectrometer

Optimization of an underwater in-situ LaBr3:Ce spectrometer with energy self-calibration and efficiency calibration

A Prototype of LaBr3:Ce in situ Gamma-Ray Spectrometer for Marine Environmental Monitoring

Monte Carlo simulation of in situ LaBr gamma-ray spectrometer for marine environmental monitoring.

Energy calibration of LaBr 3 detectors using inherent radioactivity

In-Situ Seawater Gamma Spectrometry with LaBr3 Detector at a Nuclear Power Plant Outlet

Automated spectra analysis of in situ radioactivity measurements in the marine environment using NaI(Tl) detector

Monte Carlo Study on Detection Efficiency of Seawater Measuring in-situ γ Detectors

Response of LaBr3:Ce Scintillation Detector Itself to Fast Neutrons

Design of a Prototype in-situ Gamma-ray Spectrometer for Deep Sea

Quantitative Analysis and Efficiency Study of PSD Methods for a LaBr3:Ce Detector

A Study on Neutron Energy Spectrum Estimation by LaBr3:Ce Detector

THE APPLICATION OF LaBr_3(Ce) GAMMA RADIATION SCINTILLATION SPECTROMETER TO DIRECT DETERMINATION OF URANIUM CONTENT OF URANIUM ORE BODIES

Monte Carlo Simulation of in Situ Gamma-Spectra Recorded by NaI (tl) Detector in the Marine Environment

Study on the scintillation performance of CLLB:Ce scintillator and optimization of measurement method

Efficiency calibration and self-attenuation correction in radioxenon measurement using β-γ coincidence method

Developing the radium measurement system for the water Cherenkov detector of the Jiangmen Underground Neutrino Observatory

Performance improvement of underwater LIBS qualitative and quantitative analysis by irradiating with long nanosecond pulses.

Spatially uniform calibration of a liquid xenon detector at low energies using K83mr

In-situ Gamma-spectrum Measurement for Marine Radioactivity near the Coastal Nuclear Power Plants

FAST TIMING: LIFETIME MEASUREMENTS WITH LaBr3(Ce) SCINTILLATORS