Abstract:To study the temperature distribution and evolution during bulk metallic glasses fabrication, finite element method was taken to simulate the cooling process in glassy alloys fabricated by water quenching and copper mold casting. The temperature distribution and evolution in different-sized samples in the two methods were successfully reproduced. The result showed that the temperature distribution in the alloy was strongly affected by fabricating method. Two relations were then proposed to estimate the cooling rate in different-sized samples prepared by these two methods. By comparing the reported data of critical size and critical cooling rate, we showed that the reported critical size and critical cooling rate of metallic glasses didn’t follow a heat transfer relation. Those critical-sized glassy alloys actually experienced cooling rates much larger than the critical cooling rates estimated by the classical nucleation theory or experiments on milligram-scaled samples. It results from the increasing degree of heterogeneity with sample size, and therefore a larger sample requires a faster cooling rate to avoid crystallization. This work clearly shows the temperature field evolution in bulk metallic glasses fabrication and reveals that the critical cooling rate of metallic glasses might be size-dependent.

Cooling-rate Dependence of the Density Ofpd40ni10cu

Effects Of The Cooling Rate On The Plasticity Of Pd40.5ni40.5p19 Bulk Metallic Glasses

Effects of the Cooling Rate on the Plasticity of Pd 40.5 Ni 40.5 P 19 Bulk Metallic Glasses

Influence of quenching rate on the crystallization behaviors of Mg63Ni22Pr15 metallic glass

The Influence of Cooling Rate on the Hardness of Pd–Si Binary Glassy Alloys

Pd40Ni40Si5P15 Bulk Metallic Glass Properties Variation As a Function of Sample Thickness

Cooling Rate Effect of Nanomechanical Response for A Ti-Based Bulk Metallic Glass

Glass Forming Ability and In-Situ Composite Formation in Pd-based Bulk Metallic Glasses

Effects of cooling rate and sub-Tg annealing on Ni80P20 metallic glass: A molecular dynamic (MD) study

Structural Behavior of Pd40Cu30Ni10P20 Bulk Metallic Glass below and above the Glass Transition

Effect of Cooling Rate on the Bending Plasticity of Zr55Al10Ni5Cu30 Bulk Metallic Glass

Critical Cooling Rate and Thermal Stability for a Ti–Zr–Ni–Cu–Be Metallic Glass

The Effect of Ni Substitution on the Glass-Forming Ability and Mechanical Properties of Mg–Cu–Gd Metallic Glass Alloys

The Effect of Purification on the Glass-Forming Ability of a Pd-Cu-Si Alloy

The Effect of Cooling Rate on the Wear Performance of a ZrCuAlAg Bulk Metallic Glass

Pd-Si Binary Bulk Metallic Glass Prepared at Low Cooling Rate

Elevating the Fracture Toughness of Cu49Hf42Al9 Bulk Metallic Glass: Effects of Cooling Rate and Frozen-in Excess Volume

A Study of Cooling Process in Bulk Metallic Glasses Fabrication

EFFECT OF HOT ISOSTATIC PRESSING ON MECHANICAL PROPERTIES OF Fe41Cr15Mo14C15B6Y2Co7 BMG

Elastic Properties of Pd40Cu30Ni10P20 Bulk Glass in Supercooled Liquid Region

Preparation and Thermal Stability of Pd_(77.5)Cu_6Si_(16.5) Bulk Metallic Glass