Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

A Novel Flow Channel Design to Achieve High Temperature Homogenization in Solid Oxide Fuel Cell

A novel flow field design with flow re-distribution for advanced thermal management in Solid oxide fuel cell

Design of novel flow channels of tubular biomass-syngas fueled SOFC towards uniform temperature distribution

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

Numerical Study of Temperature Distribution in Tubular Segmented-in-series SOFC with Co-Flow and Counter-Flow Arrangements

Flow Manifold Optimization for a Uniform Velocity Distribution in a Laminated Microreactor with Micro‐Pin‐Fin Arrays

Flow Uniformity Optimization for Large Size Planar Solid Oxide Fuel Cells with U-type Parallel Channel Designs

Effect of Radial Flows in Fuel Channels on Thermal Performance of Counterflow Tubular Solid Oxide Fuel Cells

Experimental investigation of temperature distribution in solid oxide fuel cells

Thermal Management of Bypass Valves for Temperature Difference Elimination in a 5 Kw Multi-Stack Solid Oxide Fuel Cell System

A Reduced-Order Electrochemical Model for Analyzing Temperature Distributions in a Tubular Solid Oxide Fuel Cell Stack

Optimization of interconnect flow channels width in a planar solid oxide fuel cell

Flow uniformity analysis and optimization of a 60-cell external manifold solid oxide cell stack with bottom-accesses

Local heat generation management for temperature gradient reduction in tubular solid oxide fuel cells

Local heat transfer enhancement by recirculation flows for temperature gradient reduction in a tubular SOFC

Numerical Simulation of Flow Distribution for External Manifold Design in Solid Oxide Fuel Cell Stack

A novel design of inlet/outlet header structure for improving flow uniformity and performance in planar solid oxide fuel cell

Analysis on temperature uniformity in methane-rich internal reforming solid oxide fuel cells (SOFCs)

Numerical Modeling of Manifold Design and Flow Uniformity Analysis of an External Manifold Solid Oxide Fuel Cell Stack

Numerical Analysis of Thermal Stress for a Stack of Planar Solid Oxide Fuel Cells

A Novel Application of Bypass Valve for Temperature Difference Mitigation Between the Multi-Stack in a 5kw Solid Oxide Fuel Cell System