Abstract:The safe disposal and utilization of municipal solid waste incineration fly ash (MSWI FA) has emerged as a crucial challenge, primarily due to elevated levels of heavy metals and chlorides. In this study, the influence of key factors in different pretreatment methods on the physicochemical properties of MSWI FA was analyzed, and the effects and mechanism of different pretreatment methods on the resulting geopolymers were studied. Under the conditions of a liquid-solid ratio (L/S) of 7mL/g, a rotational speed of 500r/min, and a stirring time of 20min, the alkali washing with 1mol/L NaOH solution exhibited better effect than water washing. The total content of chlorides and the content of soluble chloride in AFA (MSWI FA with alkali washing) were 1.53% and 0.85%, respectively. Alkali washing had a greater influence on the migration of heavy metals from MSWI FA to filtrate than water washing. Meanwhile, alkaline washing exhibited better effect in calcium retention and sulfur removal. The pretreatment process enhanced the gel formation in geopolymers, subsequently exerting a significant influence on the compressive strength and leaching concentration of heavy metals. Thermogravimetric analysis showed the bound water content in AG (8.46%) was the greatest in all simples, indicating that exerted the most pronounced impact on the gel formation during geopolymerization. And, the lower ratio of Si-O-Na to Si-O-T in AG (0.20) indicated a longer geopolymeric chains, which explained the higher compressive strength of geopolymers during the initial curing period. This article provides a new pretreatment method to promote the resource utilization of MSWI FA.

Study on Preparation of Polysilicate Chloride Aluminum and Ferric Flocculant with Fly Ash

Preparation and Application of Slag Compound Flocculant

Research on the preparation of composite polysilicic acid flocculants and their performances

Study on the preparation of polysilicate ferric flocculant and its treatment of high turbidity tailings water

Study on Preparation and Flocculation Properties of Inorganic Polymer Flocculant Polyferric Silicate Sulfate (Pfss)

The Production and Application of Complex Flocculant Polysilicate Aluminium Ferric(PSAF)

Preparation and Applications of Inorganic Polymer Flocculant Poly Aluminum Ferric Sulfate

Direct preparation of polysilicic acid flocculant by using pickling waste liquor of metal plate

Primary study on synthesis of PPFS and its application for depositing lead from wastewater

Study on the flocculation condition of Poly-Silicate-Aluminum-Ferric (PSiAF) coagulant prepared with coal gangue as raw material

Aluminum and iron leaching from power plant coal fly ash for preparation of polymeric aluminum ferric chloride

Study on preparation and surface modification of precipitated silica obtained from fly ash

Characterization and coagulation–flocculation performance of a composite coagulant: poly-ferric-aluminum-silicate-sulfate

Study on Leaching at the Early Stage of Highly Efficient Flocculants

Experimental Study on Preparation of Polymeric Ferric Phosphoric Sulfate by Bio-oxidation Andfractal Characteristics of Flocs at Different Preparation Parameters

High-efficiency leaching of Al and Fe from fly ash for preparation of polymeric aluminum ferric chloride sulfate coagulant for wastewater treatment

Study on the Performance of a Novel Inorganic Polymeric Flocculant

Synthesis of PSAFS Using Bayer Red Mud and Its Flocculation Effect Evaluation

Further Synthesis and Application of Polyphosphate Ferric Sulfate

Optimization of Hydraulic Condition on Flocculation for Micro-polluted Water

Impacts of Alkaline Washing Pretreatment on Municipal Solid Waste Incineration Fly Ash (MSWI FA) and Resulting Geopolymers