Abstract:The field of local conductivity measurement has produced many kinds of scanning probes to measure the electricalcharacteristics at the nanoscale. However, due to the design limitations, no appropriate probe has been developed to measureand simultaneously image the electrical characteristics at 100 nm order. This research aims to fabricate a four-pOint AFMprobe in order to image electrical characteristics at 100 nm ord Four-point atomic force microscope probe for imaging the electrical characteristics of materials Lin ZHANG", Yang JU*2 and Atsushi HOSOI*2 *1Nagoya Univ. Dept. of Mechanical science and Engineering Furo-cho, Chikusa-ku, Nagoya 464-8603, Japan The field of local conductivity measurement has produced many kinds of scanning probes to measure the electrical characteristics at the nanoscale. However, due to the design limitations, no appropriate probe has been developed to measure and simultaneously image the electrical characteristics at 100 nm order. This research aims to fabricate a four-point AFM probe in order to image electrical characteristics at 100 nm order. Specifically, a certain tape of AFM probe for cell measurement e.g . Biolever, can be etched into four independent electrodes with an in-between space of 200 nm. The four electrodes are basically used to measure the electrical potential drop by allowing the electric current to pass through. The four-point probe is then integrated into a multimode AFM to realize the scanning and imaging simultaneously. The present experimental results show that the four-point probe fabricated can be used to image the surface topography of the Au nanowire, thereby permitting the simultaneous measurements of surface profiles and electrical characteristics of the samples at the next stage.

Evaluation Method of Nanostructure Fabricated by SPM in Electrical Field

A Methodology for Quantitative Evaluation of Local Electrical Conductivity: from Micron to Submicron

SPM-based Nanofabrication Using a Synchronization Technique

3-D finite element calculation of electric field enhancement for nanostructures fabrication mechanism on silicon surface with AFM tip induced local anodic oxidation

G030083 Four-point Atomic Force Microscope Probe for Imaging the Electrica1 Characteristics of Materials

Quantitative Evaluation of Local Permittivity of Semiconductor Nanomaterials Using Microwave Atomic Force Microscopy

A Stitching Method for AFM Based Large Scale Scanning with High Resolution

Nano-fabrication System Based on Atomic Force Microscopy

Nanoscale In-Plane Displacement Evaluation by AFM Scanning and Digital Image Correlation Processing

Methodology for Measurement of Submicron Metallic Wire's Local Electrical Conductivity by Applying Four-points AFM Probe Technique

AFM Tip-Based Fabrication of Silicon Nanostructures with Reduced Subsurface Amorphous Layers

Surface Patterning for Multi-Scale Strain Analysis of In-Situ Sem Mechanical Experiments

Measurement of Sub-Surface Microstructures Based on a Developed Ultrasonic Atomic Force Microscopy

Enhancement of Sensitivity for the Evaluation of Electrical Properties by Modifying the Nano Structure of Microwave Afm Probe

Fabrication of a microscopic four-point probe and its application to local conductivity measurement

Nanofabrication of the gold scanning probe for the STM-SECM coupling system with nanoscale spatial resolution

High-spatial-resolution composition analysis of micro/nano-structures with a nanoscale compositional variation

Scanning Probe Lithography: State-of-the-Art and Future Perspectives

Graphene with scanning probe microscopy: A review

Recent Advances on in Situ SEM Mechanical and Electrical Characterization of Low-Dimensional Nanomaterials.

Fabrication of nanoscale to microscale 2.5D square patterns on metallic films by the coupling AFM lithography