Abstract:Monolithic silica aerogels (SiO2) are prepared using the tetraethylorthosilicate (TEOS) as precursor via a rapid supercritical extraction method (RSCE). The effect of heat treatment on the textural and physical characteristics of RSCE-samples are compared with those of the other two conventional supercritical extraction method, i.e. the alcohol supercritical extraction (ASCE) and CO2 supercritical extraction (CSCE). This new RSCE method offers many distinct advantages. The precursor recipe employs TEOS, ethanol, water, diluted hydrochloric acid to catalyst hydrolysis, and ammonia to accelerate the condensation rate. One advantage is the relative simplicity of this method: liquid precursors are poured into the supercritical ethanol drying apparatus following the hydrolysis of the TEOS and the solutions are directly sent to the supercritical extraction point of ethanol without previous aging and solvent exchanges procedures as would be the case for conventional aerogel. Thus, it is much more cost-saving and it produces little waste during the overall fabrication. The total fabrication time from mixing the precursors to taking out can be shortened to as low as 6h, which is much less time consuming than the conventional ones (usually ca. 4–7days). All the as-dried SiO2 samples derived from different methods are essentially amorphous, and SiO2 crystallization first occurs for the ASCE sample at 1100°C. The average pore diameters of the as-dried ASCE, CSCE and RSCE samples are 12.70nm, 14.97nm and 13.80nm, respectively, which is consistent with the results of transmission electron microscopy (TEM) analysis. The specific surface area of the as-dried RSCE silica aerogel may reach 915.9m2/g after 700°C, which is larger than the other two samples. The thermal conductivities of the different fiber reinforced RSCE SiO2 aerogel composites are ca. 0.027Wm−1K−1, comparable to the ASCE and CSCE aerogel composites. The RSCE method can also be well applied to the fabrication of aerogels based on other precursor recipes.

Prepararion of Ni/SiO_2 Composite Aerogel by Sol-Gel Process of Ni-containing Tetraethyl Orthosilicate

Sol-Gel Preparation, Characterization and Hydrogenation Property of Silica Supported Ni Catalyst

Preparation and Characterization of Hydrophobic Mesoporous SiO2 Aerogel

Preparation of monolithic titania aerogels with high surface area by a sol–gel process combined surface modification

Synthesis and characterization of SiO2-Al2O3 composite aerogel using inorganic aluminum salt as raw material

Preparation of Methyltrimethoxysilane Derived Silica Aerogel Films via Ambient Pressure Drying

Novel Al2O3–SiO2 composite aerogels with high specific surface area at elevated temperatures with different alumina/silica molar ratios prepared by a non-alkoxide sol–gel method

Preparation and Characterization of High Surface Area Zro2 Aerogel Modified by Sio2

Synthesis of Al2O3-SiO2 aerogels with low thermal conductivity and high strength by methyltriethoxysilane as a silica precursor

Preparation of silica aerogel from rice hull ash by drying at atmospheric pressure

Synthesis of a novel Al 2 O 3 –SiO 2 composite aerogel with high specific surface area at elevated temperatures using inexpensive inorganic salt of aluminum

Preparation of Silica Aerogels Monoliths from Hydrophobic Silica Gels and Pluronic10R5 via Sol–Gel Process

Synthesis and Textural Evolution of Mesoporous Si3N4 Aerogel with High Specific Surface Area and Excellent Thermal Insulation Property Via the Urea Assisted Sol-Gel Technique

Preparation and Thermo-Mechanical Properties of Modified Gelatin Reinforced SiO2 Aerogels

Preparation of High-Temperature Resistant Aerogels by Incorporating Aluminum Sol into Composite Silica Sources Using Ambient Pressure Drying

A New Rapid and Economical One-Step Method for Preparing Sio2 Aerogels Using Supercritical Extraction

Investigation of compound state of SiO2-TiO2 aerogel synthesized through controlled sol-gel reaction

Study on Silica Aerogel Modified by Trimethylchlorosilane

A Novel Na2O-B2O3-SiO2 System Aerogel

Preparation and Structural Evolution of SiOC Preceramic Aerogel During High-Temperature Treatment

Evolution of the Novel C/SiO2/SiC Ternary Aerogel with High Specific Surface Area and Improved Oxidation Resistance