Abstract:ZrB2-based 2-based ceramics typically necessitate high temperature and pressure for sintering, whereas ZrB2-SiC 2-SiC ceramics can be fabricated at 1500 degrees C using the process of reactive melt infiltration with Si. In comparison to the conventional preparation method, reactive synthesis allows for the more facile production of ultra-high temperature ceramics with fine particle size and homogeneous composition. In this work, ZrSi2, 2 , B4C, 4 C, and C were used as raw materials to prepare ZrB2-SiC 2-SiC via combination of tape casting and reactive melt infiltration herein referred to as ZBC ceramics. Control sample of ZrB2-SiC 2-SiC was also prepared using ZrB2 2 and SiC as raw materials through an identical process designated as ZS ceramics. Microscopic analysis of both ceramic groups revealed smaller and more uniformly distributed particles of the ZrB2 2 phase in ZBC ceramics compared to the larger particles in ZS ceramics. Both sets of ceramics underwent cyclic oxidation testing in the air at 1600 degrees C for a cumulative duration of 5 cycles, each cycle lasting 2 h. Analysis of the oxidation behavior showed that both ZBC ceramics and ZS ceramics developed a glassy SiO2-ZrO2 2-ZrO 2 oxide layer on their surfaces during the oxidation. This layer severed as a barrier against oxygen. In ZBC ceramics, ZrO2 2 is finely distributed in SiO2, 2 , whereas in ZS ceramics, larger ZrO2 2 particles coexist with glassy SiO2. 2 . The surface oxide layer of ZBC ceramics maintains a dense structure because the well-dispersed ZrO2 2 increases the viscosity of glassy SiO2, 2 , preventing its crystallization during the cooling. Conversely, some SiO2 2 in the oxide layer of ZS ceramics may crystallize and form a eutectic with ZrO2, 2 , leading to the formation of ZrSiO4. 4 . This leads to cracking of the oxide layer due to differences in thermal expansion coefficients, weakening its barrier effect. An analysis of the oxidation resistance shows that ZBC ceramics exhibit less increase in oxide layer thickness and mass compared to ZS ceramics, suggesting superior oxidation resistance of ZBC ceramics.

Heterogeneous Oxidation Behavior and Kinetic Mechanisms of SiBCN Ceramic with Structure of MA-SiBCN Coated by PDCs-SiBCN

Heterogeneous Oxidation Involving Different Atomic Clusters in Sintering-Free Amorphous SiBCN Ceramic with MA@PDC-SiBCN Structure

Comparative study on the microstructure evolution and crystallization behavior of precursor-derived and mechanical alloying derived SiBCN

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Oxidation Behavior of Amorphous and Nanocrystalline SiBCN Ceramics – Kinetic Consideration and Microstructure

Heterogeneous Oxidation of Different Atomic Clusters in Amorphous SiBCN Ceramic Associated with Phase Separation

Microstructure and high-temperature properties of SI-B-C-N MA-powders and ceramic

Microstructural evolution and oxide layer structure of Csf/SiBCN composites during oxidation at 1500 °C

Preparation, Microstructures, Mechanical Properties and Oxidation Resistance of SiBCN/ZrB2–ZrN Ceramics by Reactive Hot Pressing

Enhanced Mechanical Properties and Thermal Shock Resistance of Si2BC3N Ceramics with SiC Coated MWCNTs

Fabrication of Dense SiBCN Monolith at a Lower Temperature Andits High-Temperature Performance

Effect of Si/C Ratio and Their Content on the Microstructure and Properties of Si–B–C–N Ceramics Prepared by Spark Plasma Sintering Techniques

Oxide Scale Microstructure and Scale Growth Kinetics of the Hot-Pressed SiBCN-Ti Ceramics Oxidized at 1500 °C

SiAlC ceramics from a new polyaluminocarbosilane: Synthesis, structure and oxidation behaviors

Microstructure and Oxidation Behavior of ZrB2-SiC 2-Sic Ceramics Fabricated by Tape Casting and Reactive Melt Infiltration

Microstructures, Mechanical Properties and Oxidation Resistance of Sibcn Ceramics with the Addition of Mgo, Zro2 and Sio2 (mzs) As Sintering Additives

Novel Csf/SiBCN Composites Prepared by Densifying Csf/MA-SiBCN with the PIP Process: Oxidation Behavior and Damage Mechanism

Influences of Novel Si2BC3N Antioxidant on the Structure and Properties of Al2O3-SiC-C Castables: in Air and Coke Bedded Atmosphere

Carbon content-dependent microstructures, surface characteristics and thermal stability of mechanical alloying derived SiBCN powders

Microstructure, Oxidation and Thermal Shock Resistance of Graphene Reinforced Sibcn Ceramics

Effects of boron addition on the high temperature oxidation resistance of dense sSiBCN monoliths at 1500 °C