Abstract:A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm². The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP1 dB) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S₁₁ is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36-mW.

Design of K-band Compact Wideband Low Noise Amplifier

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

Analysis and Design of Wideband Low Noise Amplifier with Digital Control

Design of a Broadband Ka-band MMIC LNA Using Deep Negative Feedback Loop.

Design and Optimization of a Milli-Meter Wave Amplifier Using Nano-Scale CMOS Devices

A K-/Ka-Band Broadband Low-Noise Amplifier Based on the Multiple Resonant Frequency Technique

Design of Ka band Low Noise Amplifier Based on 65nm CMOS Technology

A Compact Wideband CMOS Low Noise Amplifier With Gain Flatness Enhancement

A 18–44 GHz Low Noise Amplifier with Input Matching and Bandwidth Extension Techniques

Design of a Wideband Low Noise Amplifier for 70-1000Mhz Frequency Range

A Compact LNA with 23.3 dB Gain and 3.4 dB NF for V-Band Phased Array Systems in 65-nm CMOS Technology

A Wideband CMOS LNA Using Transformer-Based Input Matching and Pole-Tuning Technique

Analysis and Design of a 2-40.5 GHz Low Noise Amplifier With Multiple Bandwidth Expansion Techniques

28 GHz Compact LNAs with 1.9 Db NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques in 65nm CMOS

A 54.4–90 GHz Low-Noise Amplifier in 65-nm CMOS

3–10 GHz, 6.54‐mw CMOS Ultrawideband Low‐noise Amplifier Using a Hybrid Structure

A High Linearity Wideband LNA with an Excellent Gain Flatness for S-band Application

A W-Band Low Noise Amplifier with High Gain and Low Noise Figure in 65-Nm CMOS

A Wideband Low Noise Amplifier for Ultra Wide Band System