Abstract:A wideband low-noise amplifier (LNA) with low and flat noise figure (NF) is presented in this article. For conventional wideband noise matching, the noise performance in the high-frequency region of the entire wideband is usually deteriorated due to the frequency-dependent nature of the minimum noise figure (NFmin) for a MOSFET. To address this issue, a novel wideband noise matching approach aiming at noise matching in high band is proposed. This approach can reduce the NF in high band at the cost of a slight NF increase in low band, eventually achieving a low and flat NF and thus a better overall noise performance for a wideband LNA. In addition, the multistage noise matching technique is employed at high frequencies to further reduce the NF caused by the second amplification stage. To validate the proposed techniques, a two-stage LNA prototype was designed and fabricated using a 65 nm CMOS process. The experimental results indicate a peak gain of 16.6 dB with a −3 dB bandwidth (BW) from 7.2 to 27.3 GHz (a fractional BW of 116%). Within the entire band of interest, the simulated NF is low and almost constant (3.3–3.4 dB), while the measured NF falls within the range of 3.30–3.72 dB. Considering the uncertainty of NF measurement, a 0.21 dB NF flatness is one of the best results among the reported millimeter-wave wideband LNAs. The measured third-order input intercept point (IIP3) is −6 dBm at 20 GHz, while the power consumption is 13.2 mW. In addition, only two passive transformers are used in this design, leading to a compact chip core area (0.14 mm2).

A Compact Wideband CMOS Low Noise Amplifier With Gain Flatness Enhancement

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A Wideband BiCMOS Thermal Noise Canceling Low Noise Amplifier with Temperature Compensation

A 6.5-12 GHz Balanced Variable Gain Low-Noise Amplifier with Frequency-Selective Non-Foster Gain Equalization Technique

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

A BiCMOS Implementation of Noise Canceling Low Noise Amplifier for Wideband Applications

A Compact LNA with 23.3 dB Gain and 3.4 dB NF for V-Band Phased Array Systems in 65-nm CMOS Technology

A Broadband CMOS LNA for WLAN Applications

A 54.4–90 GHz Low-Noise Amplifier in 65-nm CMOS

28 GHz Compact LNAs with 1.9 Db NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques in 65nm CMOS

A 28-nm E-band low noise amplifier with minimum 3.8 dB noise figure

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

A 2.8–10-GHz CMOS Current Reuse Cascaded Linearity Improving Ultra-Wideband Low-Noise Amplifier

A 2.4 GHz Gain-controlled CMOS Low Noise Amplifier

A dual band CMOS two-stage variable gain low noise amplifier

Inductorless CMOS Low Noise Amplifier for Multiband Application in 0.1–1.2 GHz

1.8-V 3.1-10.6-GHz CMOS low-noise amplifier for ultra-wideband applications