Abstract:A numerical simulation of a single-junction bilayer of CIGS-based solar cell tandem device is presented in this paper. The structure used here is Al:ZnO/CdS/CuIn1-XGaXSe2/CuIn1-YGaYSe2, and the software used is wx-AMPS. As most of the efficient high-performance photovoltaic devices are strongly dependent upon Ga content, the variation of Ga ratio is a necessary approach in the investigation of CIGS solar cells. As a result, different Ga grading profiles have been demonstrated and thoroughly analyzed the different solar cell parameters viz. open-circuit voltage (Voc), short-circuit current density(Jsc), fill factor, external quantum efficiency and efficiency (η) of the above structure under AM 1.5 illumination. At an initial process, we analyzed the single layer of CIGS (CuIn0.69Ga0.31Se2) solar cell device and its output characteristics. In the second step, we have shown the impact of tandem structure with the addition of a second CIGS absorber layer with different Ga concentrations and its improved performance as compared with a single absorber layer device. We also proposed for the first time a solution to the issue of diffusion (unintentional Ga grading) which occurs at the time of annealing at higher temperatures by adding a p-type MoS2 layer in between the bilayer CIGS to limit the diffusion and to achieve the proposed grading. The efficiency of the bilayer device structure with fixed Ga fraction x = (0.31) of the top absorber layer along with Ga fraction y = (0.45) of the bottom absorber layer shows the improved efficiency from 20.56% (single layer) to 23.6% (bilayer). Addition of a p-type MoS2 layer in between the bilayer CIGS further improves the efficiency from 23.6 to 24.17%.

A Bilayer Substrate Dynode for the Performance Improvement of Box-and-grid Electron Multiplier

Performance improvement of a discrete dynode electron multiplication system through the optimization of secondary electron emitter and the adoption of double-grid dynode structure

3D Structure of Box-and-grid Electron Multiplier with Higher Electron Collection Efficiency

Inter-dynode Voltage Optimization of Discrete Dynode Electron Multipliers by Numerical Simulation

Enhancement of the Gain and Stability in a Discrete Dynode Electron Multiplier Through Differential Voltage Distribution among Dynodes

Numerical Simulation of Characteristics of Box Type Electron Multiplier

Nanoceramic Processing for High-Power Multi-channel Electron Multiplier in Low Temperature Cofire Ceramic (LTCC)

A universal gain theory of the multiplying layer in EBCMOS based on elastic and inelastic scattering

Development and Research of W-Band Multiplier Based on Schottky Barrier Diodes with Pt/Ir Contacts

Optimization design of the large area Dynode-MCP-PMT

Transmission Secondary Electron Multiplication for High-Speed Pulse Counting

A Non-axisymmetric Structure Multistage Depressed Collector for Sheet Beam VEDs

Improving 2D Schottky Contacts Using an Intralayer Strategy

The construction and characterization of MgO transmission dynodes

New method for the measurement and simulation on the characteristics of two-dimensional electron multipliers

Bilayer CIGS-based solar cell device for enhanced performance: a numerical approach

Optimization of Active Layer Morphology for High-Efficiency Layer-by-Layer Organic Solar Cells with 18.13% Efficiency

Simulations of Multi-layer GEM Systems from Single to Quadruple GEMs

The design and analysis of the mechanism of multi-layered back-contact buffer for CdTe solar cells

Optimizing Bilayer Electrolyte Thickness Ratios for High-Performing Low-Temperature Solid Oxide Fuel Cells

Charge Transport and Extraction of Bilayer Interdiffusion Heterojunction Organic Solar Cells