Abstract:This paper introduces an automatic intelligent design method for the modified uni-traveling carrier photodetector (MUTC-PD). The conventional photodetector design process often relies on the numerical solution of complex nonlinear partial differential equations to simulate and optimize device performance, which is not only computationally intensive but also inefficient. To overcome this challenge, we apply the charge control principle to calculate the photodetector bandwidth, which improves the computational speed by a factor of approximately 1800 compared to the numerical solution of nonlinear partial differential equations. To further optimize the structure of the photodetector, we incorporate the Velocity Varying Climbing Particle Swarm Optimization (VVCPSO) algorithm. This is an improved algorithm based on the traditional particle swarm algorithm, which is able to quickly find the optimal solution in a complex parameter space. By applying the VVCPSO algorithm, we successfully fine-tuned the photodetector structure and obtained structural parameters with optimal performance. Our thorough verification process confirms that the proposed method is consistent with the results of ATLAS simulation software. Automated design has resulted in a high-performance MUTC-PD with a responsivity of 0.52A/W and a bandwidth of 60 GHz (@-3 V) at a mesa diameter of 16µm. Compared to the pre-optimized device, the bandwidth is increased to three times the original. By reducing the mesa diameter to 4µm, the bandwidth can be further increased to 82 GHz (@-3 V). The proposed method's calculation speed is fast enough, enabling extensive parameter studies to optimize device performance.

Optimization design of the large area Dynode-MCP-PMT

Optimizing the design of ultrafast photomultiplier tubes

Simulation design of a new MCP-PMT with large photocathode area and high time resolution

R&D of ultra-fast 8 × 8 anodes MCP-PMT

A Novel ZVS High Voltage Power Supply for Micro-Channel Plate Photomultiplier Tubes

Development of Lownoise, Highgain Microchannel Plate

Development and Characterization of Sub-100 Ps Photomultiplier Tubes.

A performance evaluation system for photomultiplier tubes

Automated intelligent design of modified uni-traveling carrier photodectors

Performance improvement of a discrete dynode electron multiplication system through the optimization of secondary electron emitter and the adoption of double-grid dynode structure

Performance testing of a novel short axis photomultiplier tube for the HUNT project

A New Compact Position-Sensitive PMT for Scintillation Detectors

Investigation and optimization of the deconvolution method for PMT waveform reconstruction

Air-Transfer Production Method for Large-Area Picosecond Photodetectors

THE DESIGN OF THE SHIFTING SECTION OF AN INTENSIFIER SILICON TARGET PICK-UP TUBE

Design and Optimization of Direct-Conversion Photon-Counting Detector for Dual-Energy Ct Imaging

Design and optimization of MUTC photodiode performance under high-power operating conditions

Research progress on long lifetime MCP-PMT for the DTOF detector in STCF

Characteristics of fast timing MCP-PMTs in magnetic fields

Analysis and Optimization of Spatial Resolution for a Neutron Sensitive Microchannel Plate Detector