Abstract:The 20kt Liquid Scintillator (LS) JUNO detector is being constructed by the International Collaboration in China, with the primary goal of addressing the question of neutrino mass ordering (hierarchy). The main challenge for JUNO is to achieve a record energy resolution, ~3% at 1MeV of energy released in the LS, which is required to perform the neutrino mass hierarchy determination. About 20 000 large 20-inch PMTs with high Photon Detection Efficiency (PDE) and good photocathode uniformity will ensure an approximately 80% surface coverage of the JUNO detector. The JUNO collaboration is preparing equipment for the mass tests of all PMTs using 4 dedicated containers. This approach allows us to test 144 PMTs in parallel. The primary measurement in the container will be the PMT response to illumination of its photocathode by a low-intensity uniform light. Each of the 20 000 PMTs will undergo the container test. Additionally, a dedicated scanning system was constructed for sampled tests of PMTs that allows us to study the variation of the PDE over the entire PMT photocathode surface. The core of the scanning station is a rotating frame with 7 LED sources of calibrated short light flashes that are placed along the photocathode surface covering zenith angles from the top of a PMT to its equator. The collection efficiency of a large PMT is known to be very sensitive to the Earth Magnetic Field (EMF), therefore, understanding the necessary level of EMF suppression is crucial for the JUNO Experiment. A dark room with Helmholtz coils compensating the EMF components is available for these tests at a JUNO facility. The Hamamatsu R12860 20-inch PMT is a candidate for the JUNO experiment. In this article the container design and mass-testing method, the scanning setup and scanning method are briefly described and preliminary results for performance test of this PMT are reported.

Simulation design of a new MCP-PMT with large photocathode area and high time resolution

Fast Muon Simulation in the JUNO Central Detector

Optimization design of the large area Dynode-MCP-PMT

Performance evaluation of the 8-inch MCP-PMT for Jinping Neutrino Experiment

Large photocathode 20-inch PMT testing methods for the JUNO experiment

R&D of ultra-fast 8 × 8 anodes MCP-PMT

Optimizing the design of ultrafast photomultiplier tubes

Performance testing of a novel short axis photomultiplier tube for the HUNT project

Research progress on long lifetime MCP-PMT for the DTOF detector in STCF

Single electron charge spectra of 8-inch high-collection-efficiency MCP-PMTs

High resolution MCP-PMT readout using transmission lines

Double Calorimetry System in JUNO

Development and Characterization of Sub-100 Ps Photomultiplier Tubes.

Performance Study of the Multi-purpose Time Projection Chamber (MTPC) Using a Four-Component Alpha Source

Analysis and Optimization of Spatial Resolution for a Neutron Sensitive Microchannel Plate Detector

A study of the new hemispherical 9-inch PMT

Simulating the secondary electron avalanche of MCP by Geant4

Study on the large area MCP-PMT glass radioactivity reduction

Machine-Learning based photon counting for PMT waveforms and its application to the improvement of the energy resolution in large liquid scintillator detectors

Development of Lownoise, Highgain Microchannel Plate