Abstract:W/CuCrZr alloy composite panels are promising plasma-facing components for use in future nuclear-fusion reactors. However, the intrinsic immiscibility of W and Cu makes joining them difficult. In this study, we developed a vacuum diffusion bonding method that involves sandblasting of the W substrate surface, Cu electroplating and annealing, and subsequent vacuum diffusion bonding to realize W/CuCrZr joints with high bond strength. The morphologies and structures of the W and W/CuCrZr joints were investigated by scanning electron microscopy, X-ray diffraction, and high-resolution transmission electron microscopy. Sandblasting was found to induce the plastic deformation, roughening, and grain refinement of the W substrate surface. During Cu plating on the surface of the sandblasted W (and subsequent annealing), the Cu layer was embedded in micron-scale irregular pits on the sandblasted W surface, creating a tight bond. The shear bond strength (184 MPa) and bonding quality of a W/CuCrZr joint obtained with the sandblasting/Cu interlayer method was superior to those of a W/CuCrZr joint prepared by conventional vacuum diffusion bonding. The structural origins of this superior W/CuCrZr joint were related to a region of W and Cu interdiffusion with a thickness of approximately 30 nm. This improved vacuum diffusion bonding method for W and CuCrZr can facilitate the development of plasma-facing components for future nuclear-fusion devices. (c) 2021 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).

Study on Vacuum Melting and Casting of Tungsten and Copper with Dovetail Groove Structure

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

Study on the effect of vacuum fusion infiltration technology on the properties of tungsten/copper joining interface

Strengthening Mechanisms and Research Progress in the W/Cu Interfaces

Microstructural studies of W–10wt.% Cu composites prepared by using ultrafine composite powder

Microstructure and mechanical properties of 20Wf/30ZrCp/W composite

Fabrication and Microstructure of C/Cu Composites

Comprehensive Enhancement of the Mechanical and Thermo-Mechanical Properties of W/Cu Joints Via Femtosecond Laser Fabricated Micro/nano Interface Structures

High-strength Vacuum Diffusion Bonding of Cu-plated, Sandblasted W and CuCrZr Alloy

Microstructure, residual stresses and mechanical properties of diffusion bonded tungsten–steel joint using a V/Cu composite barrier interlayer

The effect of interface modification on fracture behavior of tungsten fiber reinforced copper matrix composites

Influence of Laser Texturing on Interfacial Bonding Strength of W/Cu Joint by Spark Plasma Sintering

Freeze-casted tungsten skeleton reinforced copper matrix composites

Performance of fine-grained W/Cu plate prepared by explosive welding with high wave impedance confinement at room temperature

Femtosecond Laser Fabricated Micro/nano Interface Structures Toward Enhanced Bonding Strength and Heat Transfer Capability of W/Cu Joining

Effect of Heating Process on Fracture Behaviors of Wf/Cu82Al10Fe4Ni4 Composites

Preparation of bulk Cu-W interpenetrating-phase composites by liquid metal dealloying

Interfacial evolution mechanism of W/Cu explosive welding interface affected by preheating

Tungsten/steel diffusion bonding using Cu/W–Ni/Ni multi-interlayer

Effect of Microstructure Refinement on Surface Morphology and Dynamic Mechanical Properties of W-Cu Alloys

Microstructure and high-temperature mechanical properties of Cu-W composite prepared by hot isostatic pressing