Microstructure, residual stresses and mechanical properties of diffusion bonded tungsten–steel joint using a V/Cu composite barrier interlayer

Qingshan Cai,Wensheng Liu,Yunzhu Ma,Haoyang Liu

DOI: https://doi.org/10.1016/j.ijrmhm.2014.09.002

IF: 4.804

2015-01-01

International Journal of Refractory Metals and Hard Materials

Abstract:Diffusion bonding is a preferred method to join W and steel for divertor applications. To minimize the residual stress induced by the large mismatch of thermal expansion coefficients and to inhibit the formation of brittle intermetallic phases, a V/Cu composite barrier interlayer was designed and examined to produce a joint between W and steel. The diffusion bonding was carried out at 1050°C for 1h under a 10MPa pressure in vacuum. Metallographic analysis revealed excellent bonding at all of the joining interfaces. Neither intermetallic compounds nor other brittle phases were found in the bonded region. Nano-indentation test across the joint interfaces demonstrated the effect of solid solution strengthening in the diffusion zone. The strength of the joint was as high as 402MPa and the failure occurred predominantly at the W substrate near the W/V interface due to the residual stress concentration.

materials science, multidisciplinary,metallurgy & metallurgical engineering