Effect of B<sub>2</sub>O<sub>3</sub>-Bi<sub>2</sub>O<sub>3</sub>-ZnO-Al<sub>2</sub >O<sub>3</sub> glass additive on sintering condition, crystal structure, and dielectric properties of BaTiO<sub>3</sub> ceramics

Yuan Qi,Liu Gao-Bin,Wang Sen
DOI: https://doi.org/10.11862/CJIC.2023.014
2023-01-01
Chinese journal of inorganic chemistry
Abstract:The effects of B2O3-Bi2O3-ZnO-Al2O3 (BBZA) glass on the sintering conditions, crystal structure, and dielectric properties of barium titanate (BaTiO3) ceramics were investigated. The results show that the addition of the appropriate amount of BBZA glass powder can effectively reduce the sintering temperature of BaTiO3 ceramics from 1 350 to 950 degrees C and make it densified. Consequently, the structure of BaTiO3 phase changed (cubic phase -> tetragonal phase) with the increase of sintering temperature after adding BBZA glass. Additionally, the Curie peak of BaTiO3 ceramics were effectively suppressed and broadened. The ceramic microstructure showed that the glass phase was uniformly distributed on the surface of BaTiO3 grains. The optimized preparing conditions for the BaTiO3 ceramics were as follows: the addition (mass fraction) of BBZA glass was 2.0% and the sintering temperature was 950 degrees C. The BaTiO3 ceramics prepared under these conditions had a dielectric constant of 1 364 and a dielectric loss as low as 1.2%. When the sintering temperature was higher than 950 degrees C, the addition amount of BBZA glass should not be greater than 2.0%, too much BBZA glass will lead to the semiconducting of BaTiO3.
What problem does this paper attempt to address?