Abstract:Highlights • Interference-free determination of impurity elements in high-purity Mg by ICP-MS/MS. • Spectral interferences were eliminated using N 2 O/H 2 as the reaction gas. • The synergistic effect of N 2 O and H 2 was used to eliminate spectral interference. • The limit of detection of analytes were in the range of 0.02–18.5 ng L − 1 . High purity magnesium is not only an important basic raw material for semiconductor and electronics industries, but also a promising new generation of electrochemical energy storage materials and biomedical materials. Impurities in high-purity magnesium affect material properties, which has become the most critical factor restricting its application. However, accurate analysis of multiple ultra-trace impurity elements in high-purity magnesium is extremely challenging. In this paper, based on the synergistic effect of N 2 O/H 2 reaction gas mixture to eliminate spectral interference of inductively coupled plasma tandem mass spectrometry (ICP-MS/MS), a new strategy for the quantification of 45 ultra-trace impurity elements in high-purity magnesium was proposed. The results indicated that the limits of detection (LOD) were in the range of 0.02–18.5 ng L − 1 ; the LODs of the challenging non-metallic elements Si and S were 18.5 and 12.2 ng L − 1 , respectively; and the LODs of all the other analytes were less than 10 ng L − 1 . Even under hot plasma conditions, LODs of alkali metal elements were also less than 5 ng L − 1 . The spike recovery of each analyte was 93.6%–107%, and the relative standard deviation (RSD) was 3.2%–6.9%, respectively. At a 95% level of confidence, no significant differences were found between the results obtained under the optimal conditions for the analyte with the developed method and the measurement results of SF-ICP-MS. The developed method indicated low LOD, high sample throughput, and complete interference elimination, demonstrating a new avenue for the rapid determination of ultra-trace elements in high-purity magnesium.

Determination of 13 Trace Impurities in High-Purity Tantalum Pentoxide by ICP-AES

Direct analysis of titanium dioxide solid powder by fluorination assisted electrothermal vaporization inductively coupled plasma atomic emission spectrometry

Highlights from Recent Literature

Determination of 14 Trace Rare Earth Impurities in High-Purity Europium Oxide by Inductively Coupled Plasma Mass Spectrometry with Membrane Desolvation

Determination of 14 trace rare earth impurities in high-purity CeO2 by inductively coupled plasma mass spectrometry with membrane desolvation

Determination of Trace Phosphorus in Cobalt-Niobium-zirconium Alloy by Inductively Coupled Plasma Atomic Emission Spectrometry

Determination of Trace Thorium and Uranium Impurities in Scandium with High Matrix by ICP-OES

Determination Of Trace Elemental Inpurities In High Purity Trimethylgallium By Inductively Coupled Plasma-Atomic Emission Spectrometry

Trace impurity analysis in uranium materials by rapid separation and ICP-MS/MS measurement with matrix matched external calibration

The value of including optokinetic nystagmus testing in electronystagmography.

Development of a novel strategy for the quantification of ultra-trace impurity elements in high-purity magnesium using inductively coupled plasma tandem mass spectrometry

Enhanced ICP-MS detection of 24 elemental impurities in complex, high matrix mineral, medicinal lanthanum carbonates according to ICH Q2 (R2)

Analysis of high-purity germanium dioxide by ETV-ICP-AES with preliminary concentration of trace elements

[Simultaneous Determination of 16 Elements in Decoction Solution of Chinese Herbal Medicine by ICP-AES].

Analytical Control over the Preparation of Pure Antimony

Determination of Metal Impurities in Titanium Dioxide Using Slurry Sample Introduction by Axial Viewing Inductively Coupled Plasma Optical Emission Spectrometry

A Reliable Calibration Method for Accurate Determination of Major and Trace Elements in Fluorapatite by LA-ICP-MS Without an Internal Standard

ICP-AES Method with Multicomponent Spectral Fitting Tests Silicon Element in High Silicious Content Alloys

Determination of tungsten in niobium-tantalum, vanadium and molybdenum bearing geological samples using derivative spectrophotometry and ICP-AES

Express X-ray fluorescent analysis of technical-grade tantalum and niobium: from raw materials to products

FAAS Method for Determination of Impurities in High Purity Lithium Carbonate